REMINGTON AS7051 Volume & Curl User Manual
- June 6, 2024
- Remington
Table of Contents
Volume & Curl
AS7051
|
---|---
Thank you for buying your new Remington® product. Please read these
instructions carefully and keep them safe. Remove all packaging before use.
WARNING: This appliance is hot. Keep out of reach of children at all
times.
IMPORTANT SAFEGUARDS
-
This appliance can be used by children aged 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been supervised/instructed and understand the hazards involved. Children shall not play with the appliance.
Cleaning and user maintenance shall not be done by children unless they are older than 8 and supervised. Keep the appliance and cable out of reach of children under 8 years.
Do not use this appliance near bathtubs, showers, basins, or other vessels containing water. -
When the appliance is used in a bathroom, unplug it after use since the proximity of water presents a hazard even when the appliance is switched off
-
For additional protection, the installation of a residual current device (RCD) having a rated residual operating current not exceeding 30 mA is advisable in the electrical circuit supplying the bathroom*.
-
Currently, the fitting in a bathroom of an electrical socket suitable or capable of operating the appliance is not permitted in the UK (see BS7671).
- If the supply cord of this unit becomes damaged, discontinue use immediately and return the appliance to your nearest authorized Remington® service dealer for repair or replacement in order to avoid a hazard.
- Always ensure the voltage to be used corresponds to the voltage stated on the unit before plugging the appliance into the mains socket.
- Keep direct airflow away from eyes or other sensitive areas.
- Do not allow any part of the appliance to touch the face, neck, or scalp.
- During use, always ensure the inlet and outlet grilles are not blocked in any way as this will cause the unit to automatically stop. If this should occur, switch off and allow the unit to cool.
- Keep the power plug and cord away from heated surfaces.
- Do not leave the appliance unattended while plugged in.
- Do not place the appliance on any soft furnishings.
- Do not use attachments other than those we supply.
- Do not set the appliance down while still on.
- Do not twist or kink the cable, or wrap it around the appliance.
- Do not use the appliance if it is damaged or malfunctions.
- Check the cord regularly for any signs of damage.
- This appliance is not intended for commercial or salon use.
PARTS
1. 1000W power handle
2. 50mm thermal mixed bristle brush
3. 30mm retractable bristle curling brush
4. 21mm thermal mixed bristle brush
5. Concentrator| 6. Speed/ heat setting switch
7. Cool shot
8. Attachment lock/release button
9. Storage bag
10. Swivel cord
---|---
INSTRUCTIONS FOR USE
- Wash and condition your hair as normal.
- Squeeze out excess moisture with a towel and comb through.
- Hairsprays contain flammable material – do not use while using this product.
- Section the hair prior to styling. Style the lower layers first.
- Select your attachment before you turn on the appliance.
- Attachments can be connected to the power handle by aligning the arrow above the attachment lock/release button with the power handle and clicking to the left to lock.
1. Plug the product into the main power supply.
2. The product can be switched on by sliding the heat/speed setting switch to position
3. Dry roots completely and dry length 90% dry, ready for styling.
4. Too dry hair use the concentrator attachment.
5. For smaller and medium curls use the 21mm thermal bristle brush. Best for use on short and medium-length or layered hair.
6. To create medium to loose curls use the 30mm retractable brush.
7. The 50mm thermal volume brush adds root volume and fullness. it can also be used to fix the ends of long hair and smooth out natural curls.
8. Select the desired temperature and speed setting using the switch on the handle.
9. To increase the setting slide the heat/speed setting switch to position .
10. For all brush attachments: Take a section of hair and place the ends around the brush. Rotate the styler allowing the hair to wrap around the barrel of the brush drying and styling as you go.
11. Hold the styler in the hair for 10-20 seconds then unwind the hair by rotating the styler in the opposite direction.
12. Allow the hair to cool before styling.
13. Let the attachments cool before removing them.
14. To remove the attachment press the attachment lock/release button, twist the attachment slightly to the right and pull the attachment away from the main housing.
15. After use, turn the appliance off and unplug.
16. Let the appliance cool down before cleaning and storing away.
Cool shot
To set your style and add shine use the cool shot function. To operate press
the cool shot button down and slide forward. Slide back to turn off.
CLEANING AND MAINTENANCE
- Unplug the appliance and allow it to cool.
- To maintain peak product performance and to prolong motor life, it is important to regularly remove any dust and dirt from the air filter grille and clean with a soft brush.
- Wipe all the surfaces with a damp cloth.
- Don’t use harsh or abrasive cleaning agents or solvents.
RECYCLING
To avoid environmental and
health problems due to hazardous substances, appliances, and rechargeable and
non-rechargeable batteries marked with one of these symbols must not be
disposed of with unsorted municipal waste. Always dispose of electrical and
electronic products and, where applicable, rechargeable and non-rechargeable
batteries, at an appropriate official recycling/ collection point.
Ref. No. AS7051
Type No. AS7051
21/INT/ AS7051 T22-7002206 Version 06 /21
Remington® is a Registered Trade Mark of Spectrum Brands, Inc., or one of its
subsidiaries
Russell Hobbs Deutschland GmbH, Am Unisyspark 1, 65843 Sulzbach, Germany
remington-europe.com
© 2021 Spectrum Brands, Inc.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>