GOODGRIPS Expandable On-the-Wall Organizer Installation Guide

June 6, 2024
GOODGRIPS

Expandable
On-the-Wall Organizer
Installation Instructions

Includes

1a. To adjust configuration of the grip locks ( B ) and hooks ( A ), remove cap ( E ) on the right side of the organizer rail ( C ).
1b. Slide grip locks and hooks off.GOODGRIPS Expandable On-the-Wall
Organizer -figure 2

Note: You can also adjust configuration after installation by removing the cap on the right side and sliding pieces off the aluminum rail. (Assure you will have room to do this before installing.)

GOODGRIPS Expandable On-the-Wall Organizer -figure 3

Slide grip locks ( B ) and hooks ( A ) back on in desired order. Reattach the cap ( E ) to the organizer rail ( C ).
GOODGRIPS Expandable On-the-Wall Organizer -figure 4Adjust the organizer rails ( C ) to the desired length for your spaceGOODGRIPS Expandable On-the-Wall Organizer -figure
5

Important Note:
Do not extend the organizer past the point at which you can see the red indicator lines on the rail. If you expose these red lines, retract rails until the lines are covered again.

GOODGRIPS Expandable On-the-Wall Organizer -figure 6

Place rails ( C ) against the wall and place included level ( D ) along the top of aluminum brackets to ensure the organizer is straight.GOODGRIPS Expandable On-the-Wall Organizer -figure
7

GOODGRIPS Expandable On-the-Wall Organizer -figure

Use a pencil to mark the wall through the two holes at either end of the rails. If the third hole in the middle is visible, mark that too.GOODGRIPS
Expandable On-the-Wall Organizer -figure p

GOODGRIPS Expandable On-the-Wall Organizer -figure m

Note: : These screws/anchors are for use on drywall. For walls of other materials, use the appropriate screws and tools.
Remove the organizer from the wall.
Drill pilot holes over the pencil markings (we recommend an inch/3 mm drill bit). Drill out the holes with a larger drill bit (we recommend a ¼ inch/6 mm drill bit).
Place anchors (H ) into the wall and push in until flush with the wall. If necessary, use a hammer or mallet to finish.

GOODGRIPS Expandable On-the-Wall Organizer -figure f| GOODGRIPS Expandable On-the-Wall Organizer -figure
c
---|---

Align holes in rails ( C ) with holes in wall.

7
GOODGRIPS Expandable On-the-Wall Organizer -figure i| GOODGRIPS Expandable On-the-Wall Organizer -figure
e
---|---

Attach rails ( C ) to the wall with screws ( G ). Gently pull on rails to ensure security before adding tools.GOODGRIPS Expandable On-the-Wall
Organizer -figure t

To UseGOODGRIPS Expandable On-the-Wall Organizer -figure
kk

To use grip locks, simply press the handle of a tool straight into the grip lock toward the wall. The grip lock will adjust to fit the handle and hold tight until you simply pull to remove the tool.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals