DELL C5522QT 4K Interactive Touch Monitor User Guide
- June 6, 2024
- Dell
Table of Contents
Dell™ C5522QT/C6522QT RS232
External Control
Application
This document defines the communication method for control of the Dell LCD
display C5522QT /
C6522QT when using an external controller.
Connectors and wiring
2.1 RS-232C Remote Access
Connector: 9-pin D-Sub
Cable: Straight cable or null modem cable
RS232 Pin Assignment (Facing Display)
This display uses RXD, TXD, and GND lines for RS-232 control.
Note 1: The RS232 cable is not provided by Dell.
2.2 LAN control
Connector: RJ-45 10/100 BASE-T
Cable: Category 5 or higher LAN cable
Note 2: The LAN cable is not provided by Dell
Communication Parameter
3.1 RS-232C Remote access
1 | Interface | RS-232C |
---|---|---|
2 | Baud rate | 9600bps |
3 | Data length | 8bits |
4 | Parity | None |
5 | Stop bit | 1 bit |
3.2 LAN control
1 | Communication system | TCP/IP (Internet protocol suite) |
---|---|---|
2 | Interface | Ethernet |
3 | Communication layer | Transport layer (TCP) |
Using the payload of a TCP segment.
4| IP address| If you need to change, Default: 10.0.50.100
Please refer “Dell Web Management for Displays” section on the User’s manual.
5| Port No.| 4661 (Fixed)
Communication Format
Control Command Syntax
[H0][H1][Len][R/W][Cmd][Data0]…[DataN][Chk] [H0] = 0x37
[H1] = 0x51
[Len] = Length
[R/W] = Read/Write
Read = 0xEB
Write = 0xEA
[Cmd] = Command
[Data0]…[DataN] = Data0~N
[Chk] = Check Sum
Reply Command Syntax
[H2][H3][Len][Reply][RC][Cmd][Data0]…[DataN][Chk] [H2] = 0x6F
[H3] = 0x37
[Len] = Length
[Reply] = Reply (0x02)
[RC] = Result Code
0 = Success
1 = Timeout
2 = Parameters Error
3 = Not connected
4 = Other Failure
[Cmd] = Command
[Data0]…[DataN] = Data0~N
[Chk] = Check Sum
Example: Get Display Name
[From PC to Display] = 37, 51, 02, EB, 01, 8E
[From Display to PC] = 6F, 37, 0F, 02, 00, 01, 44, 65, 6C, 6C, 20, 43, 37, 35,
32, 30, 51, 54, 13
CheckSum calculation
Xor byte by byte from first byte to the end of the command data stream.
Control Commands List
Information in this document is subject to change without notice.
© 2020 Dell Inc. All rights reserved.
Reproduction of these materials in any manner whatsoever without the written
permission of Dell Inc. is strictly forbidden.
Trademarks used in this text: Dell and the DELL logo are trademarks of Dell
Inc.
Other trademarks and trade names may be used in this document to refer to
either the entities claiming the marks and names or their products. Dell Inc.
disclaims any proprietary interest in trademarks and trade names other than
its own.
December 2020 Rev. A00
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>