POWERMATIC Clamp Table with MICROJIG 1792824 Instruction Manual
- June 6, 2024
- POWERMATIC
Table of Contents
#1792824 Clamp Table with MICROJIG®
Assembly Instructions
(fits PM2820EVS drill press)
Contents of carton:
1 4-pc slotted table
1 3-pc fence
1 MICROJIG®clamp kit:
2 MATCHFIT™ Dovetail Clamp
2 MATCHFIT X-Pad™
6 Dovetail bolts and wing knobs
4 Dovetail nuts
4 Phillips pan hd screws, 3/16×3/4
4 Flat washers
1 Hardware package (not shown) contains:
8 Soc Hd Cap Screws, M8x30
8 Flat Washers M8
8 Flat Hd Screws, 3/16×1/2
2 Flat Hd Screws, 3/16×1-1/4
4 Pan Hd Screws, 3/16×1-1/2
4 Flat Washers 3/16
Assembly of Clamp Table
Item numbers match those of the parts list.
Consult parts drawing if further clarification is needed.
STEP 1:
Place Bottom Board (#2) into drill press table.
Make flush with the top surface of drill press table by turning the set screws
beneath the table in or out. Secure Bottom Board with the existing
socket head cap screws.
STEP 2:
Install wing tables (#1) with M8x30 socket head cap screws and M8 flat
washers. Tighten screws. Note: Wing tables are identical.
STEP 3:
Install screws and washers into Sliding Board (#4) and Dovetail Nuts (#16)
beneath. Adjust Dovetail Nuts (#16) so that they can slide into
the slots of the center section.
STEP 4:
Assemble fence halves with the Connecting Block (#7). Install Wing Knobs (#17)
and Dovetail Bolts (#18) into the fence and slide the
structure into the table grooves.
FINISH:
Install clamps into slots as desired. The Sliding Board (#4) can be removed
for through-drilling.
Use the X-Pads for clamping board edges (see photo below).
Many configurations are possible with the Micro Jig system.
Clamp Table with MICROJIG®– Parts Breakdown
To order parts or reach our service department, call 1-800-274-6848 Monday through Friday, 8:00 a.m. to 5:00 p.m. CST. Having the Model Number and Serial Number of your product available when you call will allow us to serve you quickly and accurately.
- Non-proprietary parts, such as fasteners, can be found at local hardware stores or may be ordered from Powermatic.
WARNING: This product can expose you to chemicals including lead which is
known to the State of California to cause cancer and birth defects or other
reproductive harm. For more information go to http://www.p65warnings.ca.gov.
WARNING: Drilling, sawing, sanding, or machining wood products generates
wood dust and other substances known to the State of California to cause
cancer. Avoid inhaling dust generated from wood products or use a dust mask or
other safeguards for personal protection. Wood products emit chemicals known
to the State of California to cause birth defects or other reproductive harm.
For more information go to http://www.p65warnings.ca.gov/wood.
427 New Sanford Road
LaVergne, Tennessee 37086
Phone: 800-274-6848
www.powermatic.com
Powermatic
427 New Sanford Road
LaVergne, Tennessee 37086
Ph.: 800-274-6848
www.powermatic.com
Document No. M-1792824
Edition 1 07/2020
Copyright © 2020 Powermatic, a division of JPW Industries
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>