Festive Lights SL218 Solar Powered Stone Grey Cascading Water Feature Instruction Manual

June 17, 2024
Festive Lights

Solar Water Feature
SL218
Outdoor use

These instructions contain important information which is required when using this product for the first time. Please ensure you read all the following information carefully before first use. Please retain this information for future reference.
Note:

  1. Charge the pump unit for a minimum of 1-2 days before the pump is used for the first time.
  2.  The LED lights will only work when it is dark. To test them during the day, turn the solar panel upside down and minimize exposure to sunlight.
  3.  The LED lights have been pre-assembled in the fountain body and cannot be removed.

 OVERVIEW

1.1 The solar pump is designed for use with the accompanying fountain only. For outdoor use only. In order to make the solar pump work, the solar panel requires direct sunlight. When there is sufficient sunlight, the solar pump will start to work automatically. It will stop working when the solar panel does not get sufficient light. If the fountain is used in the evening, the built-in LEDs will automatically light up to enhance the water feature.
1.2 This solar panel contains a battery pack. When the battery pack is charged it will be used to run the pump and LEDs when there is insufficient sunlight. It can be switched on and off using the switch on the back of the solar panel.

ASSEMBLING AND USING YOUR PRODUCT

2.1 Carefully remove all of the components out of the packaging.
2.2 Fill the fountain with clean tap water.
2.3 Place the pump into the reservoir ensuring that it is fully submerged under the water.
2.4 Connect the cable from the pump to the back of the solar panel, ensuring the connection is secure and tightly fastened.
2.5 Connect the LED light cable to the female socket, attached to pump. Ensure the connection is secure and tightly fastened.
2.6 Place the solar panel in an area where the maximum amount of sunlight is possible.
2.7 Press the on/off switch on the back of the solar panel to turn the pump on.Festive Lights SL218 Solar Powered Stone Grey Cascading Water Feature -
PRODUCT WARNING

  • For decorative purposes only.
  • Keep out of reach of children and animals.

Risk of strangulation.

  • Keep away f rom sources of heat.
  • Check regularly for signs of wear and tear, discontinue use immediately if damaged.
  • Dispose of product accordingly. Individual LED bulbs cannot be replaced.
  •  Do not allow the pump to run dry.
  •  Do not lift the pump with the power cord.
  •  For technical advice consult Festive Light Ltd.

CLEANING AND MAINTENANCE

Pump: After a period of time, the pump may start to lose power or stop working. Check for a buildup of sediment, scale or dirt in the filter. Remove the pump cover and the impeller cover. Clean and rinse them thoroughly with fresh water only.Festive Lights SL218 Solar Powered Stone Grey Cascading
Water Feature - CLEANING AND MAINTENANCESolar panel: The panel should be cleaned regularly with a soft damp cloth only. Do not use chemical, solvents, or abrasive cleaning materials. Regular cleaning of the panel is advised to maintain optimum performance.

TROOBLESHOOTING

6.1 The pump does not operate even though the solar module is in full sunlight.
No connection to the solar panel – check connections to the solar panel.
Impeller is blocked – To clean the pump, remove the front plate and the impeller. Use a small soft4 brush or run under a tap to remove any debris.
6.2 The pump does operate but there is no water running through the fountainhead – check for a buildup of sediment or scale in the tubes or the filter- clean the tubes and the filter.

 STORAGE

7.1 Please charge the battery for 1-2 days in direct sunlight after a prolonged period of storage.
7.2 In order to maintain the life of the battery, please charge the solar panel to the fully charge status before storing.

TECHNICAL DATA

Solar Panel: 3W
Solar Pump Operation Voltage: 9V DC
Solar Pump: 1.6W
Water Flow Max. 250LPH
Water Light Max.: 1.2M
LED Light 2 LED white light
Cable Length 5M
Lithium Battery: 7.4V/2000mAH
Pump Waterproof Rate: IP68
Panel Waterproof Rate: IP44

OPERATING INSTRUCTION

Turn on the solar mode: for first time to use, press the button to turn on the pump, the pump will run, (ref to battery status) in battery mode and switch to solar mode automatically. The pump will stop working when light becomes limited, it will automatically begin operating again the next day once it is in direct sunlight (solar mode). For general daily use, it is recommended to keep the fountain running in solar mode. Turn on the battery mode: in the nighttime or on a cloudy day, if you need the pump to run, press the switch again to turn on the battery mode, the pump will run, (ref to battery status) until the battery runs out. The pump will turn back to solar mode automatically the next time the panel is placed in direct sunlight. Stopping the pump: Press the button and hold the switch for 3 seconds. This will switch off the pump.
Quick charge the battery: Under good conditions, solar power will run the pump and any additional energy will be used to the battery at the same time. To charge the battery quickly, press and hold the on/off switch 3 seconds to turn OFF the pump. The battery will then continue to charge until full whilst in sunlight. Battery status: Green: Battery is fully charged. The pump will run around 4-6 hours.
Orange: Battery is half charged. The pump will run around 2-4 hours. Red: Battery needs charges. The pump will run less than 1 hour.
Note: The indicator light blinks when the pump is on. The indicator light is solid when the pump is off and charging battery. To protect the battery, don’t manually turn on the pump frequently.

Weather:| 1. Pump is on
2. Charge extra solar energy to battery| 1. Pump is off
2. Charge full solar energy to battery
---|---|---
| Solar power the pump will run and charge the battery. Pump performance is maintained when a cloud passes. The pump continues to run for 30 minutes after the sun has gone down.| Battery should be fully charged in approx. 1 day.
| Solar power will run the pump and charge the battery. Performance is maintained when clouds pass. The pump will run for a shorter period of time into the evening.| The battery will take 2 to 3 days to fully charge.
| The pump will only run when there is sufficient power from the battery. Little or no battery charg- ing occurs so pump performance is not maintained.| The battery will take several days to fully charge.
| No solar power is available, the pump will not run and the battery will not charge.| Battery will not charge.

UK importer: Festive Lights Ltd, Preston Road,
Charnock Richard, Chorley, Lancashire, PR7 5HH
Festive Lights SL218 Solar Powered Stone Grey Cascading Water Feature -
icon

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Festive Lights User Manuals

Related Manuals