Sensata Lithium Battery Settings User Guide

Sensata Lithium Battery Settings User Guide

QUICK REFERENCE GUIDE

Using the Magnum Energy ME-RC or ME-MR Remote Controls, set Magnum Energy inverter/chargers to charge lithium iron phosphate (LFP) batteries.

 Access LFP battery settings via built-in RV control panels using the ME-RVC bridge.

STANDARD LFP SETTINGS AVAILABLE FOR THE FOLLOWING MAGNUM ENERGY INVERTER/CHARGER MODELS

• MS2000
• MS2012
• MS2812
• MS2024
• MS4024
• MS4048
• MSH3012M
• MSH3012RV
• MSH4024M
• MMS1012
• MMSA1012

ME-RC Remote Control

From the ME-RC Remote Control version 2.9 or higher, program your Magnum Energy inverter/charger to charge lithium batteries.

• STEP ONE: Set the Low Battery Cutout to battery manufacturer’s specifications.

  • Press Setup

  • Rotate to Low Battery Cutout
    

  • Press Rotary Knob to select
    

  • Rotate to battery manufacturer’s specs, or 11.0 VDC if not specified.
    

  • Press Rotary Knob to save
    

• STEP TWO: Set the Absorb Time setting to battery manufacturer’s specifications. The setting is determined by the 20-hour amp-hour capacity of your battery bank.

  • Press Setup
    

  • Rotate to Absorb Time
    

  • Press Rotary Knob to select
    

  • Rotate to 1 hour
    

  • Press Rotary Knob to save

• STEP THREE: Set the Battery Type setting to LFP.

  • Press Setup
    

  • Rotate to Battery Type
    

  • Press Rotary Knob to select
    

  • Rotate to LFP
    

  • Press Rotary Knob to save
    

ME-MR Remote Control

From the ME-MR Remote Control version 1.3 or higher, program your Magnum Energy inverter/charger to charge lithium batteries.

• STEP ONE: Set the Battery Amp Hours to 200 AH = 1 hour.

  • Press Menu/Home button until the display shows BAT AHRS

  • The current “saved” setting is indicated by an arrow in the bottom right-hand corner of the display

  • Press On/Off/Change button until 200 AH is shown

  • Press Save/Hold button to save the 200 AH setting

• STEP TWO: Set the Battery Type setting to LFP.

  • Press Menu/Home button until the display shows BAT TYPE

  • The current “saved” setting is indicated by an arrow in the bottom right-hand corner of the display

  • Press On/Off/Change button until LFP is shown

  • Press Save/Hold button to save the LFP setting

• STEP THREE: Set the Low Battery Cutout to battery manufacturer’s specifications.

  • Press Menu/Home button until the display shows LBCO

  • The current “saved” setting is indicated by an arrow in the bottom right-hand corner of the display

  • Press On/Off/Change button until correct Low Battery VDC setting is shown for your battery specs, or 11.0VDC if not specified.

  • Press Save/Hold button to save the LBCO setting

Guide provided for reference only. Please read the full Owner’s Manual for each remote control.

www.sensata.com

CONTACT US
651-653-7000
800-553-6418
InverterInfo@sensata.com
Power Conversion
www.Magnum-Dimensions.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>