THERMCO ACCD0973IR Wall Mount Automat Forehead IR Infrared Thermometer User Guide
- June 6, 2024
- THERMCO
Table of Contents
THERMCO ACCD0973IR Wall Mount Automat Forehead IR Infrared Thermometer
Introduction
Specification
- Accuracy: ±1.0 93.2 -113°F I ±0.5 34-45°C place it in the operating environment for 30 minutes before use.
- Abnormal automatic alarm: flashing +Di Di”sound
- Automatic measurement: measuring distance 2.0 – 3.9 I Scm -10cm
- Screen: Digital display
- Power: DC 5V with included USB wall charger.
- Install method: nail hook, double-sided adhesive sticking, bracket fixing
- Environment temperature: 50-104°F I 10-40°C (recommended … 59-95°F I 15-35°C)
- Infrared measuring range: 32-122°F I o-s0c
- Response time: 0.5s
- Battery: Use only recomended (18650 Li-ion) rechargeable battery. Battery not included.
- Weight: 12.4oz I 350g
- Dimensions: 6.7 x 4.3 x 5.5 inch I 170 x 115 x 140mm
- Standby: About one week
- Counting capacity: 999
Status Descrition
- Standby: The red dot in the bottom of the display lights up in tum. (Fig. 1)
- Insufficient power: The horizontal bar lights up in the middle of the display. (Fig. 2)
- Normal temperature: Flashing green lights and alarm ‘Di’. (Fig. 3)
- Abnormal temperature: Flashing red lights and alarm ‘Di Di’.(Fig. 4)
- Default (bod:object mode)
‘Lo’: Ultra-low temperature alarm. (Fig.5)
‘HI’ : Ultra-high temperature alarm.(Fig. 6)
0peration Instruction
-
Temperature measurement: Stand in front of the IR thermometer within a distance of 2.0 – 3.9 Inch I Scm – 10cm (Fig. 7).
-
Mode Switch: There is a small hole on the back of the device (Fig. 8).
(2a) Temp Scale: Use a paper clip to insert in hole and press mode switch to select C: Celsius or F: Fahrenheit (Fig.9, 10) (2b) Scanning Mode: Long press of mode switch for 3 seconds to change the scanning mode to (Sur: surface mode, bod: body mode, Cou: counting mode) -
lnstall and replace battery
(3a) Remove three screws
(3b) Open the beck base and install 18650 Li battery -
lnstall method
Warning
- lt is the user’s responsibility to ensure the electromagnetic compatibility environment of the device so that the device can work normally.
- lt is recommended to evaluate the electromagnetic environment before using the device.
- When changing the operating environment, the device must be left to stand for more than 30 minutes.
- Please measure the forehead to the thermometer.
- lt is not recommended to use it outdoors or under strong light.
- Keep away from air conditioners, fans, etc.
- Please use qualified, safety-certified batteries, unqualified batteries or non-rechargeable batteries used may cause fire or explosion.
- lf it cannot work after install the battery, please insert the charging cable to charge it and it can be used normally.
Made in China
Read User Manual Online (PDF format)
Loading......