DeLonghi HFX65 Series Ceramic Fan Heater Instruction Manual
- October 27, 2023
- Delonghi
Table of Contents
DeLonghi HFX65 Series Ceramic Fan Heater Instruction Manual
ELECTRICAL CONNECTION (UK ONLY)
A) If your appliance comes fitted with a plug, it will incorporate a 13 Amp
fuse. If it does not fit your socket, the plug should be cut off from the
mains lead, and an appropriate plug fitted, as below.
WARNING: Very carefully dispose of the cut off plug after removing the fuse:
do not insert in a 13 Amp socket elsewhere in the house as this could cause a
shock hazard.
With alternative plugs not incorporating a fuse, the circuit must be re-fitted
when changing the fuse using a 13 Amp
Asta approved fuse to BS 1362. In the event of losing the fuse cover, the plug
must NOT be used until a replacement fuse cover can be obtained from your
nearest electrical dealer. The colour of the correct replacement fuse cover is
that as marked on the base of the plug.
B) If your appliance is not fitted with a plug, please follow the instructions
provided below:
Important
The wires in the mains lead are coloured in accordance with the following code:
Blue: Neutral
Brown: Live
As the colours of the wires in the mains lead of this appliance may not
correspond with the coloured markings identifying the terminals in your plug,
proceed as follows:
The wire which is coloured blue must be connected to the terminal which is
marked with the letter N or coloured black.
The wire which is coloured brown must be connected to the terminal which si
marked with the letter L or coloured red.
IMPORTANT SAFEGUARDS
Danger!
Failure to observe the warning may result in life threatening injury by electric shock.
- The appliance must not be placed immediately under a fixed power socket.
- Do not use the appliance near showers, bathtubs, sinks, swimming pools, etc.
- If the power cable is damaged, it must be replaced by the manufacturer, an authorized service centre or a qualified electrician in order to eliminate all risk.
Important!
Failure to observe the warning could result in injury or damage to the appliance.
-
This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.
-
Children of less than 3 years should be kept away unless continuously supervised.
-
Children aged from 3 years and less than 8 years shall only switch on/off the appliance provided that it has been placed or installed in its intended normal operating position and they have been given supervision or instruction concerning use of the appliance in a
safe way and understand the hazards involved. Children aged from 3 years and less than 8 years shall not plug in, regulate and clean the appliance or perform user maintenance.
CAUTION — Some parts of this product can become very hot and cause burns. Particular attention has to be given where children and vulnerable people are present. -
ATTENTION : To avoid the safety system resetting accidentally, this appliance must not be powered through an external on/off device such as a timer, or connected to a circuit which is turned off and on regularly by the energy supplier.
-
Do not use the appliance in small rooms when they are occupied by persons that are not capable of leaving the room, unless constant supervision is provided.
Extra Europe market only:
- This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
Danger of burns!!
Failure to observe the warning could result in burns or scalds.
- WARNING : To avoid overheating, never under any circumstances cover the appliance during operation as this would lead to a dangerous rise in temperature.
Please note:
This symbol indicates recommendations and important information for the user.
-
Always use the appliance in an upright position.
-
The use of extension leads is not recommended.
However if they cannot be avoided, follow the instructions accompanying the extension lead and never exceed the power limit marked on the extension. -
The heater must be positioned at least 50 cm from furniture or other objects.
-
Do not use the appliance in rooms with a floor area of less than 4m2.
-
Before putting the appliance away, make sure it is completely off and unplugged from the mains socket. Wrap the cable around the base.
Do not store in dusty atmospheres. -
Do not rest anything on the appliance.
-
Do not use the appliance to dry laundry. Do not obstruct the air intake and outlet grilles (danger of overheating).
-
Do not use the appliance near walls, furniture, curtains, etc.
Safety functions
-
Safety device: the appliance is fitted with a safety device which switches it off in the event of accidental overheating (e.g. obstruction of air intake and outlet grilles, motor turning slowly or not at all).
To reset, unplug the appliance from the mains socket for a few minutes, remove the cause of overheating then plug in again.
If the appliance doesn’t work please contact the
De’Longhi Customer Service. -
Tip over safety device: a tip over safety device turns the appliance off if it falls over or is positioned inappropriately in such a way as to jeopardise safety.
The appliance emits a beep and a dot flashes on the display. The appliance resumes operation a few seconds after being placed in an upright position again.
Disposing of the appliance
The appliance must not be disposed of with household waste, but taken to an authorised waste separation and recycling centre.
INTRODUCTION
Thank you for choosing a De’Longhi product.
Please take a few minutes to read these instructions.
This will avoid all risks and damage to the appliance.
DESCRIPTION
A ON/STAND-BY button
B +/- Adjustment buttons
C Oscillation button
D “ECO PLUS” function button
E Timer button
F MODE button (for selecting the operating mode)
G Power indicator light
H Back cover with filter
I Receiver for remote control (certain models only)
USE
Installation
The appliance can be used on any horizontal surface.
Do not overload the electrical circuit. Avoid using the same socket for other
appliances.
Electrical connection
- Before plugging the appliance into the mains socket, check that the mains power supply corresponds to the value indicated on the rating plate and that the mains power supply is adequate for the load.
- THIS APPLIANCE COMPLIES WITH DIRECTIVE 2004/108/ EEC ON RADIO INTERFERENCE SUPPRESSION.
Operation and use
– Connect the appliance to the power outlet.
– The appliance emits a beep and the power indicator light (G) also comes on
and remains lit while power to the appliance is on. The appliance goes into
STAND-BY.
– Press the ON/STAND-BY button (A) to turn on the appliance. It will begin to
heat with the predefined settings.
– Press the MODE button (F) to select one of the following functions
available:
♦ Ventilation
In this operating mode only the fan operates, so the
appliance does not heat the room.
♦ Anti-freeze
In this operating mode the appliance keeps the room at a temperature of 7°C to
prevent freezing temperatures.
♦ Heating 1 and Heating 2
In this operating mode you can set the desired temperature by pressing the +
and – adjustment buttons (B).
– Heating 1 (minimum power level):
The appliance operates at the minimum power, reducing noise and energy
consumption to the minimum.
– Heating 2 (maximum power level):
The appliance operates at the maximum power for rapid heating of the room.
– To turn off the appliance press button ON/STAND-BY
(A). The display could show the count down for about 6 seconds. To completely
turn off the appliance, remove the plug from the socket.
Please note: The display can show the temperature in both °C and °F. To change the temperature scale, press and hold the + key for few seconds, then release.
ECO PLUSfunction
In this operating mode the appliance will automatically set the power level to
guarantee the best comfort reducing the energy consumption.
The maximum temperature setting is 26 °C. To activate this function, press the
ECO PLUS button (D).
Oscillation button
If you want the appliance to distribute the airflow over a larger area, press the oscillation button (C) . The appliance will then oscillate right and left. To stop the oscillation in the desired position, just press oscillation button (C) again.
24-HOUR DIGITAL TIMER
This function can be activated from any operating mode.
Delayed switch-on : with the appliance in the STAND-BY position, press
the timer button (E) .
The display shows the symbol and the time remaining before switch-on. To set
the timer, use the + and – adjustment buttons (B), then wait a few seconds for
the programming to be set. The display returns to show for stand-by and the
symbol to indicate you have set the timer.
When the programmed time has been reached, the appliance turns on with the
same settings it had during the previous operation.
Delayed shut-off: With the appliance on, press the timer
button (E) .
The display shows the symbol and the time remaining before shut-off. To set
the timer, use the + and – adjustment buttons (B), then wait a few seconds for
the programming to be set. The display returns to show the current settings
and the symbol to indicate you have set the timer.
When the programmed time as been reached the appliance shuts off
automatically. If you want to go back to operation without the timer, press
the timer button (E) twice.
The timer symbol disappears from the display
Using the remote control (certain models only)
The remote control functions correspond to those on the control panel. See the section “Operation and Use” on the previous page for a description of the functions.
Inserting or replacing the batteries
Fig.1
-
The remote control is provided with a lithium battery CR2032. To let the appliance function, remove the battery cover strip, by pulling it.
-
To replace the batteries, remove the battery cover by rotating it.
Replace the battery paying attention to respect the right polarity as shown in figure 1. -
Replace the cover rotating it towards the position .
-
Old batteries must be removed and disposed off in accordance with current legislation as they are harmful to the environment.
Extra Europe market only:
Important!
- WARNING – KEEP BATTERIES OUT OF REACH OF CHILDREN.
- Swallowing may lead to serious injury in as little as 2 hours or death, due to chemical burns and potential perforation of the oesophagus.
- Examine devices and make sure the battery compartment is correctly secured. Do not use if compartment is not secure.
- Dispose of used button batteries immediately and safely. Flat batteries can still be dangerous.
MAINTENANCE
- Before carrying out any maintenance, always unplug from the mains socket.
- During the season when the appliance is in use, clean the air intake and outlet grilles regularly using a vacuum cleaner.
- Never use abrasive powders or solvents to clean the appliance.
- The dust filter which retains impurities in the air, It is integrated in the removable back cover. To clean the filter, remove the grille by pulling outward. Blow it lightly, then replace it into the appliance.
TECHNICAL CHARACTERISTICS
TROUBLESHOOTING
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>