rule DB412 Series Dry Bilge Pump with Panel Switch Installation Guide
- June 6, 2024
- rule
Table of Contents
DB412 Series
Dry Bilge Pump with Panel Switch
Installation Instructions
- The Rule Bilge Pump is self-priming up to 9.5ft (3m).
- Install the Rule Bilge pump in a clean, dry location. (This is not a submersible pump.)
- Uses multi-positional ports for easy mounting of the pump.
- If mounted vertically, the motor should be above the pump head.
- Use rubber grommets provided to absorb vibration.
- Use 3/4″ (19mm) i.d. spiral reinforced hose (with a smooth internal bore), or semi-rigid pipework systems.
- Connect the hose to the inlet and outlet of the pump using stainless steel hose clamps.
- All suction connections must be airtight and free of sharp bends or restrictions.
- Inlet hose should run to the deepest point of the bilge area.
- Run the discharge hose from the pump to the 90° thru-hull.
- Inlet hose should be cut at an angle in the bilge and be secured on a bulkhead or stringer with stainless steel clamps to pick up all of the bilge water.
- Install the thru-hull with a water-tight sealant and above the waterline of the vessel.
- Secure all plumbing hoses to a bulkhead or stringer.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>