Clear-Com WH301A Wireless Headphones User Manual

Clear-Com WH301A Wireless Headphones

Model : WH301A Wireless Headphones

Package List

• Wireless Headphones xl
• 3.5mm Audio Cable xl
• Headphones Carrying Case xl
• User Manual xl
• Charging Cable xl

Diagram

1. Volume+ button/ next song
2. Multi-function button
3. Volume- button I previous song
4. LED indicator
5. 3.5mm audio port
6. Type-C charging port
7. Microphone
8. ANC Button
9. ANC switch indicator
10. Noise reduction hole

Media Playback & Volume Functions

Call Functions

Decline an incoming call

| Press and hold 11 MFB11  button for 2 sec while a call is coming

Switch to mobile phone

| Press and hold 11 MFB” button for 2 sec during a call
Siri/Google Voice| Double-click the “MFB” button

MULTI-POINT CONNECTION

The headphones allow multiple connections. This allows two devices to be connected at the same time. You won’t get input from both devices at the same time, but you can switch seamlessly from one device to the other.
To connect the WH301 to the second device:

1. After you have connected the headphones to the first device, click MFB button to turn off the headphone temporarily. Turn on the headphone again, and long press MFB button to enter pairing mode.
2. On your second phone, go to Settings> Bluetooth List, find WH301 and connect the headphones to your second phone.
3. Go to the Bluetooth list of first phone again, reconnect the WH301A under My Device.
4. Then, the headphone will built connection with two devices, you can change the headphone connection between the two smartphones back and forth.

ANC CONNECTION
Turn on the ANC button on the headphones to suppress outside noise. Reminder: ANC mode can only be activated when the headphone is powered on. Even in wired mode, you need click MFB button to turn on the headphone first, then, click ANC button to active ANC function.

Clear Paired Device
Long press the “MFB” button and the Volume 11-11 button simultaneously until the red and blue lights flash 3 times at the same time.

Charge the Headphones
In Charging: Red led light stays on.
Full Charge: Blue led light stays on (charging for 2.5 hours) .

FCC STATEMENT:

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:

1. This device may not cause harmful interference,
2. This device must accept any interference received, including interference that may cause undesired operation.

FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.

NOTICE:
Note: This equipment has been tested and found to comply with these limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
4. Consult the dealer or an experienced radio/TV technician for help.

ISEDC RSS Warning:

This device complies with Innovation, Science and Economic Development Canada Compliance licence-exempt RSS standard (s).
Operation is subject to the following two conditions:

1. this device may not cause interference, and
2. this device must accept any interference, including interference that may cause undesired operation of the device.

ISEDC Radiation Exposure Statement:
This equipment complies with ISEDC RF radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

Caution:

1. To reduce the risk of electrical shocks, fire, etc
   • Do not disassemble or modify the equipment.
   • Do not allow flammable, water or metal objects to enter the equipment.
2. Avoid using the headphones
   • In places with high humidity or excessive dust
   • In places where the temperature is extremely high (over 40 °C or 104 °F) or low temperature (below 5 °C or 41 °F).

PRECAUTIONS FOR USE:

• Do not use any USB cable other than the one provided.
• Do not use the supplied USB cable with any other devices.
• Store earplugs in a safe place out of the reach of children to avoid possible accidents or dangers.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>