HONSENN HS-BN928 Bluetooth ANC Headphone Instructions
- June 6, 2024
- HONSENN
Table of Contents
HONSENN HS-BN928 Bluetooth ANC Headphone Instructions
Bluetooth ANC Honsenn Headphone
TOUCH PANEL
RIGHT SIDE
TURN ON
Press the POWER button for 3 sec. You will hear the sound prompt and, a few seconds later, the “Bluetooth pairing on• voice prompt. The LED on the right earcu p will turn blue andthen will start flashing blue/red. In case the head phones have been previously connected to the smart device, instead of “Bluetooth pairing on”, you will hear the “Connected” voice prompt and the LED will start flashing blue/green slowly.
Turn off
Press and hold the POWER button for 4 sec. You will hear the “Power off” voice prompt Tile blue LED will light up for a sernnd and will go off.
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>