THINKERRIDE Smart Bicycle Computer Meter User Guide
- June 6, 2024
- THINKERRIDE
Table of Contents
THINKERRIDE Smart Bicycle Computer Meter User Guide
INSTALLATION GUIDE
KEY INTRODUCTION AND OPERATION
SMART METER KEY
A-key function
Tips: The APP can also control the recording
Click “Start riding” on the home page to enter the page of cycling data record
; Click start recording, suspend recording and stop recording; the meter will
synchronize your operation , try it now ~
B-key function
C-key function
CHARGING
Open the dust cover to perform USB charging.
Provide support for charging and using
STEPS OF APP CONNECTION
CONNECT APP OF THINKERRIDE
Scan and download Thinkerride to complete the following operations
1. START THE SMART STOP-WATCH
Keep the cycling instrument power on, and press > for short time to open
the Bluetooth connection information
2. MATCH WITH APP OF THINKERRIDE
a. Register and log in APP. Enter the home page and click the [+] button on
the upper right corner to add device button
b. Enter the device connection page and click and search Bluetooth button
c. Select the Bluetooth address of the device in the device selection box, to
connect
APP OPERATION GUIDE
CALLER AND MESSAGE SETTINGS
smart meter supports caller reminder, SMS reminder and mobile phone
application reminder to let you not miss any important information on the way
of riding and make your riding more safe. In APP- My Settings – Mobile Message
Reminder, customize the reminder content.
CHECK THE RIDING DATA
After each riding, the APP will actively and synchronously store your riding
data. In APP- Home Page – Sports Data Record, check all the sports data.
HOW TO NAVIGATE DYNAMICALLY
Start APP to start navigation. Smart meter will display dynamic navigation
synchronously. On the APP- Home – Map – Navigation page, plan the navigation
destination.
SETTINGS
When APP connects smart meter, In APP- Home – smart meter Settings, set the smart meter.
FCC Statement
This device complies with part 15 of the FCC rules. Operation is subject to
the following two
conditions: (1) this device may not cause harmful interference, and (2) this
device must accept
any interference received, including interference that may cause undesired
operation. Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.a
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
Read More About This Manual & Download PDF: