aroco AC-BW-R120 Wifi Bridging Device for Low Energy RF Beacon Instructions
- June 6, 2024
- aroco
Table of Contents
aroco AC-BW-R120 Wifi Bridging Device for Low Energy RF Beacon
Industrial grade Client Receiver
AC-BW-R120 is WIFI client bridging device for receiving RF Beacon information. The device will send the beacons information to the application server through the existing WIFI network
Electrical Specification
- RF beacon Reception
- Bluetooth 5 Compatible
- iBeacon Compatible
- Chipset: Nordic NRF52840
- 256kB RAM, 1MB Flash
- Frequency: 2.4GHz
- Transmission
- 802.11bgn
- Frequency: 2.4GHz
- Power Input
- 5VDC Input 1.2meters USB Cable
- Reserve 9-36VDC Input Port
- RF Reception protocol
- BT4.2 Advertise or/and Long Range (PHY Coded) Mode
- Range upto 200m (with Long-Range Phy Coded)
Report Format
AC-BW-R120 Device report iBeacon Format data such as RSSI, Channel Index, MAC
address, UUID, Major, Minor, Manufacturer code; Or report whole RAW data
packet for non-iBeacon Format data in RAW mode. 
Environmental Specification
- Operating temperature: : -25°C to +75°C
- IP66
- UV resistance
- Material: PC/ABS
Transmission Protocol (Through WIFI network)
- MQTT
AROCO compatible RF Beacons
- AC-BLE-T110
- AC-BLE-T110S
- AC-BLE-T110F
- AC-BLE-T110T
- AC-BLE-T110G
- AC-BLE-T110PIR
- AC-BLE-T110TP
FCC
This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by the
party responsible for compliance could void the user’s authority to operate
the equipment.
NOTE: This equipment has be interested and found to comply with the limits for
a Class B digital device, pursuant to Part
15 of the FCC Rules. The s e limits are des igned to provide reasonable p rot
action against harm fu l interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accord ance with the instructions, may cause harmful
interference e to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged t try
to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Inc released the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Radiation Exposure Statement
To comply with FCC RF exposure compliance requirements, this grant is applicable to only mobile configurations. The antennas used for this transmitter must be installed to provide a separation distance of at least 20cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter.