Zhejiang Eboy Technology EBE-BAW535 LED Lamp Instruction Manual
- June 6, 2024
- Zhejiang Eboy Technology
Table of Contents
Zhejiang Eboy Technology EBE-BAW535 LED Lamp
Description
- ITEM: EBE-BAW535
- BASE: E26
- POWER : AC 120V
- LUMINOUS FLUX: 1100 Lumens
- COLOR TEMP : RGB+2700-6500K
- LIFE SPAN: 2500 hour
- BEAM ANGLE: 220 degree
- DIMMABLE: Bright
- DIMENSION: D60*H117mm
INSTALLATION
Step 1
Screw in AEOT bulb in to socket.
Step 2
Power on and off 3 times.
Step 3
Confirm that bulb is rapidly flashing.
Step 4
Proceed to connect via AEOT.
SET-UP
FCC Statement:
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment. This
device complies with part 15 of the FCC Rules. Operation is subject to the
following
two conditions
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.