Zhejiang Eboy Technology EBEBBW502 Smart LED Lamp User Manual
- June 13, 2024
- Zhejiang Eboy Technology
Table of Contents
BEBBW502 Smart
LED Lamp
User Manual
EBEBBW502 Smart LED Lamp
The fol lowing items are included in the box
LED LAMP Manufacture: Zhejiang Eboy Technology Co.,Ltd.
INSTALLATION
STEP 1
Screw in AEoT bulb in to socket.
STEP 2
Power on and off 3 times.
STEP 3
Confirm that bulb is rapidly flashing.
STEP 4
Proceed to connect via AEoT.
SET-UP
MAKE SURE WI-Fl NETWORK IS AVAILABLE SUPPORT
FCC Caution.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.