MORPHIBIANS X615-2G4R Morphibian Sprint Instructions
- June 6, 2024
- MORPHIBIANS
Table of Contents
MORPHIBIANS X615-2G4R Morphibian Sprint Instructions
Safety Instructions
The packaging must be retained since it contains important information.
Caution:
Please read these carefully before using:
- Only adults should install and replace batteries.
- Rechargeable batteries are only to be charged under adult supervision
- Rechargeable batteries are to be removed from the toy before being charged.
- Non-rechargeable batteries are not to be recharged.
- If the device is not used for a long time, remove the batteries.
- Do not mix old and new batteries.
- Do not mix alkaline, standard (Carbon Zinc) or rechargeable (Nickel Cadmium) batteries.
- Exhausted batteries are to be removed from the toy.
- The supply terminals are not to be short-circuited.
- Only batteries of the same or equivalent type as recommended are to be used.
- Batteries are to be inserted with the correct polarity.
- Do not dispose of batteries in fire, batteries may explode or leak.
- Batteries may explode or leak if misused.
VEHICLE
- Unscrew the waterproof cover with a Phillips screwdriver to take out the USB port.
- Plug in a standard USB power supply.
- Charging time: 3 hours
- Replace the USB port and tighten the waterproof cover.
REMOTE CONTROLLER
- Unscrew the battery cover on underside of controller with phillips screwdriver.
- Insert 2-AAA batteries with polarities shown in battery compartment.
- Replace the battery cover and screw shut.
How to Play
To get the vehicle to start working, turn both power switches to “ON” position at the same time.
Trouble Shooting Tips
- When the LED light on the controller keeps blinking, the vehicle & controller are NOT paired yet. Turn controller & vehicle power switches to “OFF” position. Wait 10 seconds for reset. Turn both power switches to “ON” position again to play.
- If the LED lights on controller and vehicle are solid, the vehicle & controller are paired and ready to play.
Call Kid Galaxy at 1-800-816-1135
for help if needed.
BATTERIES
- Vehicle requires: Built-in rechargeable batteries (included)
- Controller requires: 2 AAA alkaline batteries (not included)
Specifications
- Size of Window Box: 304.8(L) x 254(D) x 222.2(H)mm
- Size of Window Box: 12″(L) x 10″(D) x 8.784″(H)inch
- Material: 250gsm CCNB + A9 Flute paper(box & insert) with diecut.
- Colour: CMYK
- Finishing: UV
- Window PET: #8
FCC Statement
WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference, including interference that may cause undesired operation.
This device complies with Industry Canada’s license-exempt RSSs. Operation is subject to the following two conditions:
- This device may not cause interference; and
- This device must accept any interference, including interference that may cause undesired operation of the device.
The toy is to be operated in water only when fully assembled in accordance with the instructions.
Customer Support
©2021 Kid Galaxy, Inc. All Rights Reserved.
MADE IN CHINA
1-800-816-1135
Kid Galaxy, Inc.
150 Dow St. Manchester, NH 03101
USA
Conforms to the safety requirements of ASTM F963 and FCC regulations. Conforms
to toys regulations of Canada Consumer Product Safety Act.
Product and colors may vary from items shown.
Contains controller and vehicle.
Proof of Purchase
© 2021 Kid Galaxy Limited
Confidential for internal use only.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>