Quanzhou Sfe Electronic Technology SD530K Digital Portable Radio User Manual
- June 6, 2024
- Quanzhou Sfe Electronic Technology
Table of Contents
Quanzhou Sfe Electronic Technology SD530K Digital Portable Radio
TROUBLESHOOTING
MAINTENANCE AND CLEANING
SPECIFICATIONS
SUBTONE TABLE
WARRANTY AND SERVICE
Use this SD530 Digital Portable radio in the environment with temperature
between 0-40 , otherwise,it may damage your Digital portable radio. It can be
operating under 2000m. Hereby,Quanzhou SFE Electronic technology Co.,Ltd.
declare that the radio equipment type SD850 Digital portable radio is
compliance with Directive2014/53/EU.
For safe operating, the antenna for the product shall be least 25 mm away from
your face and 0 mm from your body with belt clip.
The product supplied by Li-ion battery and charged from approved travel
Charger.
WARNING
WARNING! Read this information before using the radio. In August 1996 the Federal Communications Commission (FCC) of the United States with its action in Report and Order FCC 96-326 adopted an updated safety standard for human exposure to radio frequency electromagnetic energy emitted by FCC regulated transmitters.
Those guidelines are consistent with the safety standard previously set by
both U.S. and international standards bodies. The design of the radio complies
with the FCC guidelines and these international standards.
Never allow children to operate the radio without adult supervision and the
knowledge of the following guidelines.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the condition that this device does not cause harmful interference.
For a transmitter that can only be operated with an FCC license,warningss
concerning compliance with applicable licensing requirements and information
concerning license applanation procedures.
Our radio generators RF electromagnetic energy during transmit mode.
This radio is designed for and classified as “Occupational Use Only”, meaning
it must be used only during the course of employment by individuals aware of
the hazards, and the ways To Minimize Such hazards.
This radio is NOT intended for use by the “General Population” in an uncontrolled environment. This radio has been tested and complies with the FCC RF exposure limits for “Occupational Use Only”. IN addition, our radio complies with the following Standards and Guidelines with regard to RF energy and electromagnetic energy levels and evaluation of such levels for exposure to humans:
- IEEE Std. 1528:2013 and KDB447498, Evaluating Compliance with FCC Guidelines for Human Exposure to Radio Frequency Electromagnetic Fields.
- American National Standards Institute (C95.1-1992), IEEE Standard for Safety Levels with Respect to Human Exposure to Radio Frequency Electromagnetic Fields, 3 kHz to 300 GHz.
- American National Standards Institute (C95.3-1992), IEEE Recommended Practice for the Measurement of Potentially Hazardous Electromagnetic Fields-RF and Microwave.
- The information listed above provides the user with the information needed to make him or her aware of RF exposure, and what to do to as-sure that this radio operates with the FCC RF exposure limits of this radio.
Electromagnetic Interference/Compatibility
During transmissions, Our radio generates RF energy that can possibly cause
interference with other devices or systems. To avoid such interference, turn
off the radio in areas where signs are posted to do so. DO NOT operate the
transmitter in areas that are sensitive to electromagnetic radiation such as
hospitals, aircraft, and blasting sites.
Occupational/Controlled Use
The radio transmitter is used in situations in which persons are exposed as
consequence of their employment
provided those persons are fully aware of the potential for exposure and can
exercise control over their exposure.
Attention:
This radio complieswith IEEE and ICNIRP exposure limits for
occupational/controlled RF exposure emvironment at operating duty factors of
up to 50% and is authorized by the FCC for occupational use only. An
appropriate warning lable is affixed to all units. In order to comply with RF
exposure requirements, a minimum distance of 2.5cm must be maintained when
held-to-face, and body-worn operations are restricted to the approved original
acessories (belt clip)a minimum distance of 0 mm. Do not use this device when
antenna shows obvious damages .
This product is compliance to FCC RF Exposure requirements and refers to FCC
website https://apps.fcc.gov/oetcf/eas/reports/GenericSearch.cfm search for
FCC ID: 2AYFQ -SD530K to gain further information include SAR Values.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
WARNING: MODIFICATION OF THIS DEVICE TO RECEIVE CELLULAR RADIOTELEPHONE
SERVICE SIGNALS IS PROHIBITED UNDER FCC RULES AND FEDERAL LAW.
FCC Compliance Statements:
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Licensing Information
Use our radio in USA is subject to the rules & regulations of FCC. Changes or
modifications not expressly approved by our may void the user authority
granted by
the FCC to operate this radio and should not be made. To comply with FCC
requirements, transmitter adjustments should be made only by or under the
supervision of a person certified as technically qualified to perform
transmitter maintenance and repairs in the private land mobile and fixed
services as certified by an organization representative of the user of those
services. Replacement of any transmitter component (crystal, semiconductor,
etc) not authorized by the FCC
equipment authorization for this radio could violate FCC rules.
Note: Use of this radio outside the country where it was intended to be distributed is subject to government regulations and may be prohibited.
Important: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this device. Your radio is set up to transmit a regulated signal on an assigned frequency.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>