SIMRAN SMP-1800 Professional Amplified Speaker System with USB MMC FM BT and RFC Instruction Manual
- June 6, 2024
- SIMRAN
Table of Contents
SIMRAN SMP-1800 Professional Amplified Speaker System with USB MMC FM BT
and RFC Instruction Manual
Thank you very much for buying this speaker, please kindly read
instruction manual before operating the product
Product: Professional Amplified Speaker System
Model: SMP-1800
Technical Specification:
-
Amplified plastic loudspeaker.
-
Woofer: 15″, 50 oz. 65mm VC.
Tweeter: 34mm driver, 13 Oz -
Frequency response: 45Hz-20KHz
-
Sensitivity: 9822dB,
-
With USB .MMC. FM. BT Voiceprompt, Mic Priority. Record into USB/MMC. BT Upgrade TWS function: One mobile phone could be connected to two speaker
-
Power: 1800W
-
Voltage: ACI 10/220v. 60/50Hz
Notes:
- Please read the entire attached document carefully before using the device for your reference.
- The power supply must match the demand of the device with reliable ground wire.
- All covering signal should be complied with the demand Of device,
- The device should be equipped far away high temperature, moisture and powerful electro and magnetic field.
- Please don’t use the organic cleaner but dry sort cloth to clear the device.
- When not in use. unplug the unit from the mains.
- Set the unit to the lowest volume prior to switching it on.
- Only use suitable means or transportation if you want to move the speaker -BE WARE OF YOUR BACK!
-
MMC Card
-
USB Port
-
Control button ofUSB. MMC. FM. BT. RECORD
REC: RECORD is to put a USB/MMC in the speaker, through
MIC/Line in, it could to record the information within the USB/MMC -
Bluetooth light:
Red: Indicating searching for Bluetooth name
Blue: Indicating matched
-
Remote Window
-
MIC input with XLR and 6.35mm connectors
-
MIC level
-
Stereo input and output with RCA
-
Button to switch between line and MP3
-
Graphic equalizer
-
Echo effect
-
Master knob to adjust the volume of speaker
-
Line/ MP3 level
-
MIC Priority selection:
When it is on status: MIC Priority could work(When the volume of microphone reaches a certain loudness, the loudness of music will decrease) ,
When it is off: MIC Priority couldn’t work. -
Aux in
-
Power Socket and Power switch
-
Speaker Output
TWS BT Connection
FCC statement
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
FCC Radiation Exposure Statement
This device complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. This transmitter must not be co-located or operating
in conjunction with any other antenna or transmitter.
Read More About This Manual & Download PDF: