connectpoint CP42 SPX Sandpiper Digital Display User Manual
- June 6, 2024
- connectpoint
Table of Contents
connectpoint CP42 SPX Sandpiper Digital Display
Cautions: The device is installed at fixed location via trained professionals and needs to remain at least 20 centimeters away from human contact.
Open door for SIM card installation
Install SIM Card-1
Install SIM Card-2
Re-connect All Antenna
Close door
- Check the gasket seal to ensure it is clean and that there is no debris. Check the mating cover as well.
- Set the cover in place. It should rest easily on the seal, with all the wiring inside the housing.
- Tighten all 14 screws evenly, so that the seal is not damaged. Start with the center four screws, finish with the outer screws, and make two passes: first, gently snug; second, finish. Recommended torque:
Connector DC Power
Power on CP42 & Check Screen
Operation
Once the installation is complete at site and once the device is powered
on, all operation will be control and executed by private cloud from remote.
No other setting is needed.
FCC Warning
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Any changes or modifications not expressly approved by the party responsible for compliance could void the authority to operate equipment.
This device and its antenna must not be co-located or operating in conjunction
with any other antenna or transmitter.
For product available in the USA/Canada market, only channel 1~11 can be
operated. Selection of other channels is not possible
FCC RF Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator & your body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>