SMEKITLLYS02 2-Pack Small Size Universal Ceiling Fan Remote Control Kit Instruction Manual

SMEKITLLYS02 2-Pack Small Size Universal Ceiling Fan Remote Control Kit

Instruction

FCC WARNING

Waming : Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the eqlipmenl

FCC STATEMENT

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful Interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used In accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause hannful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the Interference by one or more of the following measures.

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

ATTENTION

1. Make sure the circuit breaker had been cut down before installation.
2. Electrical Installation should be performed by a qualified licensed electrician.
3. Spliced conductors should be turned upward and pushed carefully up Into the outlet box.

SPECIFICATION

• Input Voltage
  85V-264V 50/SOHZ

• Max Fan Power
  145WMAX

• Max Light Power
  50r!N MAX: Incandescent
  15cm MAX: LED lamp

WIRING SCHEMATIC DIAGRAM FOR RECEIVER

INSTALLATION INSTRUCTION

1. Cut down the ceiling fan power through the circuit breaker.
2. Note that the input and output lines are clearly identified, connect the wires correctly, must not be connected backwards, otherwise, the receiver will be damaged immediately when turned on power.
3. Reinstall fan base so that wire connections are not exposed.
4. Reconnect circuit breaker and tum on the fan power, you will hear a short sound ‘Bl’ from receiver, the lamp will tum on automatically.
5. Pressing a fan speed button will active the fan.

NOTICE

1. If your fan has PULL CHAINS switch, please switch the PULL CHAINS, on SPEED maximum and LIGHT on, this way, you can get all the remote functions.

2. The receiver has no REVERSE function, no DIMMING function.

3. IF the remote no answer, please check:

4. Does your fan have power?

5. If you have pull chain switch, and each on the correct position?

6. Did you install the receiver correctly?

7. Does the battery in remote have enough power and well contacted?

8. Are there any other wireless-controlled products with same frequency working nearby?
   They will disturb each other if they are working in very close distance.

9. Please remove away the batteries if the remote not use for a long time.

10. Please take care of the ANTENNA during your installation. Don’t damage the insulation. And put the ANTENNA outside the canopy, in order to get a good remote distance.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>