Viition 4426561 Remote for Starry Sky Projection Light Instructions
- June 6, 2024
- Viition
Table of Contents
FCC
Instructions of Remote Control
- Please pull out the insulation tape from the remote control, before starting to use it.
- Press the button to select functions. The functions are :
: turn ON/OFF the lights
: Light mode selection
: Music control
: Turn off the lights after 60 minutes
: Motor speed
Instructions of foot pedal switch control
: Power button: Long press the button for 2 seconds to start the product,
Press once to turn off Cloud Projecting, Press twice to turn off the laser
light, Press the third time to turn off the laser light, and Cloud
Projecting
Laser speed control: the default is medium speed when starting, press the
first time to switch to high speed, press the second time to switch to low
speed, press the third time to pause
Cloud Projecting speed adjustment: the default is medium speed when starting
up the press, the first time to switch to high speed, press the second time to
switch to low speed, press the third time to pause
Music control mode： Press once to turn on the sound control mode, the light
will flash in accordance with the music rhythm. Press again to OFF
RGB Light mode： Click to switch the light color.
FCC Caution.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.