MULTILINK 8T1 230V Radio Switch Transmitter User Guide
- June 6, 2024
- MULTILINK
Table of Contents
- MULTILINK 8T1 230V Radio Switch Transmitter User Guide
- Installation
- Connect the Switched Input Lin
- System Operation
- Pairing a Transmitter to Receiver
- Erasing a MULTILINK-RX
- Advanced Features – Jumper Link Setting
- Simplified Declaration of Conformity (RED)
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
MULTILINK 8T1 230V Radio Switch Transmitter User Guide
Installation
Connect the Switched Input Lin
Connect the Switching Live input to Lin.
When this input is ‘LIVE’ the Red LED will illuminate, and MULTILINK-RX will
then switch Live out at its output.
System Operation
When any transmitter(s) are active the receiver will provide a LIVE output
Only when ALL transmitters are INACTIVE, then the receiver will switch OFF its
output.
MULTILINK incorporates a “smart watchdog” failsafe, the receiver knows the status of all transmitters at all times. Whilst LIVE is present at a MULTILINK Transmitter a background “Watchdog” signal is Intermittently sent (every ~30 seconds). MULTILINK Receiver will switch its output OFF if it receives all the OFF commands from transmitters, or, has failed to receive any Watchdog signal within a two minute period from any paired transmitter.
Pairing a Transmitter to Receiver
Erasing a MULTILINK-RX
Advanced Features – Jumper Link Setting
MODE
FSK, Faster operation shorter (Line of sight up to 500m in buildings 200m.)
This mode is recommended for general operation,
LORA Mode 3, Long range Mode / Slower operation. This mode can be used where additional RF penetration / range is required.
Warnings:
- Product is not independently isolated, ISOLATE the mains electricity supply before removing the cover and observe any relevant safety precautions. Maintenance to the product that involves removal of the cover should only be carried out by a competent person or qualified electrician.
- F2 Fuse rating is 4A (T) 250 H (Ceramic). Replace fuse with same type and rating.
- Relay is rated at 10A peak, and 5A constant.
Simplified Declaration of Conformity (RED)
Hereby, RF Solutions Limited declares that the radio equipment type defined within this document is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: www.rfsolutions.co.uk
RF Solutions Ltd. Recycling Notice
Meets the following EC Directives:
DO NOT Discard with normal waste, please recycle.
ROHS Directive 2011/65/EU and amendment 2015/863/EU
Specifies certain limits for hazardous substances.
WEEE Directive 2012/19/EU
Waste Batteries and Accumulators Directive 2006/66/EC
Where batteries are fitted, before recycling the product, the batteries must
be removed and disposed of at a licensed collection point. RF Solutions
battery producer number:
BPRN00060.
WEEE Directive 2012/19/EU
Waste electrical & electronic equipment. This product must be disposed of
through a licensed WEEE collection point. RF Solutions Ltd., fulfils its WEEE
obligations by membership of an approved compliance scheme. Environment agency
number: WEE/JB0104WV.
Disclaimer:
Whilst the information in this document is believed to be correct at the time
of issue, RF Solutions Ltd does not accept any liability whatsoever for its
accuracy, adequacy or completeness. No express or implied warranty or
representation is given relating to the information contained in this
document. RF Solutions Ltd reserves the right to make changes and improvements
to the product(s) described herein without notice. Buyers and other users
should determine for themselves the suitability of any such information or
products for their own particular requirements or specification(s). RF
Solutions Ltd shall not be liable for any loss or damage caused as a result of
user’s own determination of how to deploy or use RF Solutions Ltd’s products.
Use of RF Solutions Ltd products or components in life support and/or safety
applications is not authorised except with express written approval. No
licences are created, implicitly or otherwise, under any of RF Solutions Ltd’s
intellectual property rights. Liability for
loss or damage resulting or caused by reliance on the information contained
herein or from the use of the product (including liability resulting from
negligence or where RF Solutions Ltd was aware of the possibility of such loss
or damage arising) is excluded. This will not operate to limit or restrict RF
Solutions Ltd’s liability for death or
RF Solutions Ltd
William Alexander House, William Way, Burgess Hill, West Sussex, RH15 9AG
Sales: +44 (0)1444 227900
Tech Support: +44 (0)1444 227909
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>