SOULSENS BH494B SL10 Wireless Headphone User Manual
- June 6, 2024
- SOULSENS
Table of Contents
SOULSENS BH494B SL10 Wireless Headphone User Manual
Package List
Diagram
How to Pair
Press and hold it for 2s and then the blue light will flash quickly after turning on the headsets, wait 3-5s until the red and blue flash altermately after entering pairing mode. Turn on the Bluetooth of your device, and find “SL1 0” in the list to connect.
Play/Pause/Answer/Hang up/Reject/Redial
Clear paired Device
Volume Control/Music Control
Charge the Headphone
FAQ
- Cannot turn on headphones
- Make sure the headphones are kill charged.
- Make sure the headphones are off while charging. Please disconnect the Use charging cable before you turn on the headphones.
- Cannot charge headphones
- Please use the provided USB charging cable.
- Make sure the USB charging cable is connected firmly to your headphones, USB AC adapters and computers.
- Make sure the USB AC adapters are connected firmly to your power outlets.
- No Sound from the headphones
- Make sure headphones and paired devices are turned on.
- Make sure headphones and Wireless receiving devices are connected to A2DP via Bluctooth.
- Please turn up the volume when the volume is too low.
- Make sure the paired devices are in normal operation.
- Make sure the audio output device on your PC is the BluntoottiD device when you connect headphones to computers.
- Make sure the Aux cable is connected firmly in wired mode.
AFTER-SALE SERVICE
FCC Statement
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1 ) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
FCC Radiation Exposure Statement This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
ISEDC RSS warning
This device complies with Innovation, Science and Economic Development Canada Compliance licence-exempt RSS standard (s). Operation is subject to the following two conditions: (I) this device may not cause interference, and (2) this device must accept any interferenc,e,including interference that may cause undesired operation of the device.
ISEDC Radiation Exposure Statement:
This equipment complies with ISEDC RF radiation exposure limits set forth for
an uncontrolled environment. This transmitter must not be co-located or
operating in conjunction with any other antenna or transmitter.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>