sensortouch RF3407A Remote Control User Manual
- June 6, 2024
- sensortouch
Table of Contents
sensortouch RF3407A Remote Control
appearance
PMN: REMOTE CONTROL
HVIN:RF3407A
Key function
| Buttons and LEDs | Key value | Specification |
|---|---|---|
| B1： | Foot Up | Press and hold foot up button, foot actuator moves out, stop |
when released
B2：| Head Up| Press and hold head up button, head actuator moves out, stop
when released
---|---|---
B3：| Foot Down| Press and hold foot down button,foot actuator moves in, stop
when released
B4：| Flat| Press and hold flat button, the bed goes flat
B5：| Head Down| Press and hold head down button,foot actuator moves in, stop
when released
B6：| FLASH LIGHT| Press and hold foot this button turn on the flashlight,
release the button to turn off the flashlight
B7：| HEAD UP+FOOT UP| Press and hold this button,head and foot actuator moves
out, stop when released
MASTER PAIR| HEAD UP+FLAT| Press Head up + Flat and hold on, backlight of
remote flashes and begins pairing;If succeeds, the backlight is always on,, If
fails,the backlight is always off;
SLAVE PAIR| ****
HEAD DOWN+FLAT
| Press Head Down+ Flat and hold on, backlight of remote flashes and begins
pairing;If succeeds, the backlight is always on,, If fails,the backlight is
always off;
Note:
1. When there is only one bed, the master pair function is always used. If there is any misoperation, reuse the master pair function.
2. When you have two beds and use wireless synchronization, please code them in the following order: Step 1: Use the master pair function and any one of them.
Step 2: Use the slave pair function to code with another control box.
If there is any misoperation in the above order, just start from the first step again.1.
FCC Warning
Please take attention that changes or modifications not expressly approved by
the party responsible for compliance could void the user’s authority to
operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference
that may cause undesired operation.
ISED RSS Warning:
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) This device may not cause interference, and
(2) This device must accept any interference, including interference that may
cause undesired operation of the device.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>