Quest Usa ATRONN LED Wireless Charger User Manual
- June 6, 2024
- Quest Usa
Table of Contents
Quest Usa ATRONN LED Wireless Charger
Product Introduction
Fantasy wireless charger is an intelligent product, with simple design and
compatible with any mobile phones with Qi standard. Mobile phone is without
plug when charging,which is more convenient and effcient. It can bring you
with limitless life experience as well as safe and free experience with
wireless charging function.
Product Outline
Sleek & technological sense design handy & light to carry around
Applicable Devices
- Devices with built-in wireless charging receiver(Nokia 1520,LG,Nexus 5 and more)
- Devices with reserved wireless charging interface beside it battery(Samsung Galaxy S3,S4,S5,Note2,Note3,Note4,etc).
- Devices with wireless charging receiver in its protection case(iPhone5/5s,iPhone6, iphone6 plus,etc).
Note: All devices must be Qi standard.
Instructions
- Insert one end of USB charging cable into power adaptor or computer. shown as below.
- Insert an other end of USB charging cable into Micro USB port of the wireless charger. The LED indicator lights up to indicate well connectivity.
- Place your phone on the wireless charger. Make sure that the phone is well located at the charging are a of wireless charger. when the phone is being charged, the LED indicator will light up automatically to show charging status.
Standard Accessories
- Fantasy Wireless Charger
- USB Cable
- User Manual
Product Specification
Input: 5V-2A/9V-1.67A
Output: 5V-2A/9V-1.2A
Charging Efficiency: >73%
Transmission Distance: <8mm
Attention
- Please keep the charger away from water or other liquid.
- If you need to clean the charger, please make sure it is not power supply.
- Using Environment temperature remain O-45 C
FCC statement
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: 1) this device may not cause harmful interference, and 2) this device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Radiation Exposure Statement
This device complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. This transmitter must not be co-located or operating
in conjunction with any other antenna or transmitter. During the operation of
device, a distance of 15 cm surrounding the device and 20 cm above the top
surface of the device must be respected.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>