COXSPACE Snowl Gesture Ring Mouse User Manual
- June 6, 2024
- COXSPACE
Table of Contents
COXSPACE Snowl Gesture Ring Mouse User Manual
SNOWL Definition
Machine Learning Gesture Air Mouse ‘SNOWL’
SNOWL’s 9DoF sensor and machine learning system learns and precisely analyzes the user’s finger gestures.
3d spatial coordinates measured by the 9DoF sensor are sent to your smart devices in realtime so you can control those devices using just simple finger gestures.
3Mode Mouse @For Multi Devices Control
3D Air Mouse
Joy-stick Mouse
Machin Learning Gesture @Pre-Set 8 types
- 8 preset gestures are set
- Machine learning after 5 repetitions of 8 gestures (custom gestures)
- Each gesture can be associated with a keyboard function
FCC Compliance Information
Specification
- SNOWL (Gesture Ring Mouse)(Model:COXi)
-FCC ID:2AXGBCOXI
-Operating Frequency : 2402 MHz to 2480 MHz(BLE V4.2)
-Battery : DC 3.7 V(Li-ion Battery) / Rated Input Voltage : DC 5 V - SNOWL Charger Cradle(Model:COXiC)
-FCC ID: 2AXGBCOXIC
-Battery : DC 3.7 V(Li-ion Battery) / Rated Input Voltage : DC 5 V
-USB Type : C Type
FCC NOTICE TO USERS:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications no expressly approved by the manufacturer(or party responsible) for compliance could void the user’s authority to operate the equipment.
FCC Part 15.105 Statement
Note : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications, However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
IMPORTANT NOTE:
To comply with the FCC RF exposure compliance requirements, no change to the antenna or the device is permitted. Any change to the antenna or the device could result in the device exceeding the RF exposure requirements and void user’s authority to operate the device.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>