EMERSON 101013 Go Tracker 4G/5G Global User Manual
- June 6, 2024
- Emerson
Table of Contents
EMERSON 101013 Go Tracker 4G/5G Global
CE Regulations
Caution
Risk of explosion if battery replaced aced by an incorrect type. Dispose of
used batteries according to the instructions The technical documentation
relevant to the above equipment will be held at Locus Solutions Please make
sure the temperature for the device will be from -10˚C to 45˚C. The
manufacturer specified the maximum ambient temperature for use in charging
mode of 40 ˚ and for use in the non-charge mode of 45 ˚C. The minimum
distance between the user and/or any bystander and the radiating structure of
the transmitter is 20cm.
This radio equipment operates with the following frequency bands and maximum radio-frequency power：
| Features | Description |
|---|
Frequency Band
|
GSM/GPRS: Quad band, 900/1800 LTE B1/3/8/20/28
Max. TX power
| Class 4 (+33dBm ±2dB) for GSM/GPRS 850/900 Class 1 (+30dBm ±2dB) for GSM/GPRS 1800/1900
23dBm for LTE B1/3/8/20/28
List of the Followed Test Standards for Assessment of RED Requirement
Hereby, Locus Solutions declares that the radio equipment Go Tracker 4G/5G
Global is in compliance with Directive 2014/53/EU.
The full text of the EU declaration of conformity is available at the
following internet address:
https://europa.eu/youreurope/business/product-requirements/compliance
/technical-documentation-conformity/index_en.htm
Go Tracker 4G/5G Global complies with the essential requirements of Article 3
of the RED 2014/53/EU Directive, if used for its intended use and that the
following standards have been applied:
-
Health (Article 3.1(a) of the RE Directive) Applied Standard(s):
EN 62311 :2020 -
Safety (Article 3.1(a) of the RE Directive)
Applied Standard(s): EN 62368-1:2014+A11:2017 -
Electromagnetic compatibility (Article 3.1 (b) of the RE Directive) Applied Standard(s):
ETSI EN 301 489-1 V2.2.3
Draft ETSI EN 301 489-52 V1.1.2 -
Radiofrequency spectrum usage (Article 3.2 of the RE Directive) Applied Standard(s):
ETSI EN 301 511 V12.5.1
ETSI EN 301 908-13 V13.1.1
ETSI EN 301 908-1 V13.1.1
The technical documentation relevant to the above equipment will be held at Locus Solutions
FCC Regulations:
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This device has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiated
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Changes or modifications not expressly approved by the party responsible for compliance could void the user‘s authority to operate the equipment.
RF Exposure Information
This device meets the government’s requirements for exposure to radio waves.
This device is designed and manufactured not to exceed the emission limits for
exposure to radio frequency (RF) energy set by the Federal Communications
Commission of the U.S. Government. This device complies with FCC radiation
exposure limits set forth for an uncontrolled environment. In order to avoid
the possibility of exceeding the FCC radio frequency exposure limits, human
proximity to the antenna shall not be less than 20cm (8 inches) during normal
operation.
ISED Notice
This device complies with Innovation, Science and Economic Development Canada
license-exempt RSS standard(s). Operation is subject to the following two
conditions:
- this device may not cause interference, and
- this device must accept any interference, including interference that may cause undesired operation of the device.
Contact Person: Mona Delavari
Job Title: Certification Manager
E-mail: mona.delavari@emerson.com
Address: 7121 Fairway Dr. #400, Palm Beach Gardens, FL 33418, USA
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>