MRZ-14 Selfie Ring Light Instruction Manual
- June 6, 2024
- MRZ
Table of Contents
|
---|---
|
FCC Statement Changes or modifications not expressly approved by the party
responsible for compliance could void the users authority to operate the
equipment. This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
Interference In a residential Installation. This equipment generates uses and
can radiate radio frequency energy and, If not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on. the user is encouraged to try to correct the
interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help This
device complies with part 15 of the FCC rules. Operation is subject to the
following two conditions (1 Allis device may not cause harmful interference,
and this device must accept any interference received, including interference
that may cause undesired operation.
| |
---|---|---
-
Light stand introduction
-
Light stand Adjustment
a. When the light stand locking knob is released, press down the leg to the needed angle, and then lock the light stand locking knob.
b.Turn the locking knob counter-clockwise until released, and reverse the leg 180° to fold the light stand. -
Center Column Adjustment
a.Rotate the center column locking knob counterclockwise to release and pull the center column to the desired height, then lock it.
b. Loose the flip lock according to the illustration, pull the center column to the needed height then lock it.
After-sale mailbox: huanggang@aqznice.com
Warnings:
| Do not exceed the light stand maximum load capacity.
---|---
Ensure the light stand is locked.
Do not operate this light stand when the temperature is below-20°C or above
70°C It is not commended to operate in saltwater.
Do not put this light stand in sunlight or lean against the glass of car for a
long time.
Do not leave this light stand unattended in a public place; please be careful
when use it in dangerous places.
Remove the camera from the ball head during /I\ setup or transport.
it is not necessary. to equip lubricant. Please use standard lubricant or
grease when necessary.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>