myCharge PCW10KK-A Powerpad+Cables 10K 10000mAh Internal Wireless Battery Portable Charger User Guide
- June 6, 2024
- myCharge
Table of Contents
myCharge PCW10KK-A Powerpad + Cables 10K 10000mAh Internal Wireless Battery Portable Charger User Guide
IN THIS PACKAGE:
- POWERPAD+CABLES 1 OK
- Recharging cable
- Quick start guide
RECHARGING UNPLUGGED10K
Connect the included recharging cable to any USB power source.
Fully charged unit shows 4 solid, non-blinking LEDs. 3 ways to recharge: From
wall outlet, car, computer
LED INDICATORS
CHARGING DEVICES
WIRELESS CHARGING (for enabled devices)
- A. Press power button on POWERPAD+CABLES
- B. Center device on POWERPAD+CABLES
- C. Wireless charging indicator lights up when charging begins
USB CHARGING
Using your own cable, plug the USB end into POWERPAD + CABLES and the other end into your device. Charging should begin automatically if it doesn’t, press the power button.
Simultaneously charge up to 4 devices via USB ports and wirelessly.
WARRANTY INFORMATION: At my Charge, we’re dedicated to making the highest
quality products possible. In that, we provide a one-year limited warranty
from the date of purchase. Keep a copy of your receipt as proof of purchase
and register your product at mycharge.com and check for the latest product
updates as they develop. Failure to register your product and/or to provide
proof of purchase may void the warranty.
Warranty Instructions and Information visit:
mycharge.com/warranty and select your model.
MYCHARGE SUPPORT: support.mycharge.com
WARNING: Read all instructions and warnings prior to using this product.
Improper use of this product may result in product damage, excess heat, toxic
fumes, fire or explosion, for which myCharge is not responsible.
-
Do not expose battery to heat sources, extended direct sunlight or other high-temperature environments.
-
Avoid drops and excessive impacts to the battery.
-
Do not disassemble, attempt to repair or replace any part of the housing or battery.
-
Do not attempt to charge the battery using any other method, apparatus, or connections other than the device’s charging cable.
-
Never dispose of batteries in the garbage. This is unlawful under state and federal environmental laws and regulations.
Always take used batteries to your local battery-recycling center. -
WARNING: This product contains chemicals known to the state of California to cause cancer, birth defects and other reproductive harm.
FCC COMPLIANCE: Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Statement
This device complies with part 15 and part 18 of the FCC Rules. Operation is Subject To the following two conditions:
- This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not explicitly approved by the party responsible for compliance could void the user’s authority to operate this equipment.
Note: this equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 and part 18 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and candidate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. During the operation of device a distance of 15 cm surrounding the device and 20 cm above the top surface of the device must be respected.
This device complies with Part 18 of the FCC Rules. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Increase the separation between the equipment and any other radio device.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.