AMPETRONIC UP17007-7 TalkPerfect Duplex Intercom Speech Transfer System User Guide
- June 6, 2024
- AMPETRONIC
Table of Contents
AMPETRONIC UP17007-7 TalkPerfect Duplex Intercom Speech Transfer System
User Guide
The TalkPerfect quick start guide is for basic installations only.
For more complex installations or issues with performance after setup please
refer to the full installation guide.
https://www.ampetronic.com/products/talkperfect-duplex-intercom-speech-
transfer-system/
INSTRUCTIONS
STEP-1 Check components and tools
Components (Kit Dependent):
- TP-UX
- Power Supply
- Connectors
- Client Speaker
- Client Mic
- Staff Combi Mic
Required Tools:
- Small flat bladed screwdriver
- Screws, fixings and tools for mounting (environment dependent)
Step-2 Position and wiring
Step-3 Adjust volume levels
- Ensure both Staff and Client dials are set to zero (fully counter-clockwise)
- Plug in the power supply and switch on
- Adjust the Staff control whilst someone talks on the client side, until the speaker is audible on the staff side
- Repeat the process in the other direction while adjusting the Client control
- If the volume is too quiet for the user or if there is feedback/ instability then increase or reduce the level controls as needed
For further optimization please download the installation guide from ampetronic.com or contact our friendly and knowledgeable team on +44 (0) 1636 610062 or email support@ampetronic.com.
References
- Ampetronic hearing loop system drivers and loop design - 60118-4
- Ampetronic hearing loop system drivers and loop design - 60118-4
- Speech transfer and window intercoms - Ampetronic
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>