Shenzhen Heshan Technology H8 3 In 1 Wireless Charger User Manual
- June 6, 2024
- Shenzhen Heshan Technology
Table of Contents
Shenzhen Heshan Technology H8 3
In 1 Wireless Charger
Specification:
| Input | 5V-2A，9V-2A，12V-1.5A |
|---|---|
| USB total output | 10W Max |
| Material | ABS |
Instructions: InstructionConnect the USB cable, the indicator will flash
once and then go out after the device is started. At this time, the self-check
of the device is completed, and the corresponding device can be put on for
charging.
Important tips: This product can be adapted to the watch-dial size of all
Apple watches. Just turn the watch lifter button upward (in the direction
shown in Figure A) to control the I watch lifter to move upwards, otherwise,
it can move downwards. Until the watch charging dock completely fits the watch
frame.
Warning:
- Please keep this product out of reach of children.
- Please keep this product away from heat-dissipating appliances such as radiators, or inflammable explosives.
- Do not use this product with wet hands or in a humid place.
- Do not disassemble this product by yourself. If you need technical assistance, please contact the supplier or call a qualified repairman.
Troubleshooting
- When to reset: If the product is not used for a long time, the product will automatically enter the sleep state. If it cannot charge due to a sudden power failure, it can return to normal after reconnecting to the power supply.
- Not charging: If the indicator flashes quickly when the product is charging, it indicates that the charging coil has detected metal (the foreign body detection function is activated). Please remove the relevant metal before charging.If the fault has not been resolved, please unplug the power and restart the product for normal use.
- Charging slowly: Please check whether the output voltage and current of the adapter are up to the standard. If not, you can replace the adapter with a larger output current.
FCC WARNING
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
RF warning for WPT device: The equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. During the operation of device, a distance of 15cm surrounding the device and 20 cm above the top surface of the device must be respected.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>