Shenzhen Heshan Technology S8 Multi-Function Wireless Charger Stand User Manual
- June 4, 2024
- Shenzhen Heshan Technology
Table of Contents
Heshan Technology S8 Multi-Function Wireless Charger Stand
User Manual
S8 Multi-Function Wireless Charger Stand
Multi-function wireless charger stand
User Manual
Made In China
- iwatch charging area
- Charging area for vertical mobile phone
- Charging area for horizontal mobile phone
- Mobile phone holder
- Mobile phone charging indicator
- Iwatch charging indicator
- Airpods charging area
- Airpods charging indicator
- Heat-dissipating area
- USB input port
Specifications
| Input | 9V-2A,12V-2A |
|---|---|
| Output | 15W for mobile phone area, 2.5W for iwatch area, |
| Material | 5W for airpods area ABS |
How to use:
Connect the USB cable and the indicator light will flash once and then go off after the device starts. At this time, the self-test of the device is completed. Press the Watch Pop-up button, and put on the corresponding device for charging.
Special note:
It is necessary to install the rising silicone for mobile phones when charging the iPhone 12/13MINI (all mobile phones of the remaining sizes are not required to be installed. The mode of installation is as shown in the figure below)
Warning
- Please keep this product out of the reach of children.
- Please keep this product away from heat dissipating appliances such as radiators, or flammable and explosive items.
- Do not use this product with wet hands or in wet areas.
- Do not disassemble this product by yourself. In case of technical assistance, please contact the supplier or hire a qualified repairer.
Troubleshooting
-
When to reset
In case the product is not used for a long time, the product will automatically enter into a sleep state, and in case it cannot be charged due to a sudden power failure, it can be restored after reconnecting the power supply. -
No charging
If the indicator light flashes rapidly while this product is charging, it proves that metal is detected by the charging coil (foreign object detection is activated). Please remove relevant metals and then charge again. If the failure is not removed, please unplug the power and restart this product for normal use. -
Slow charging
-
Please use the adapter supplied with this product or other original adapters above QC3.0.
-
Check if the corresponding device is aligned with the charging coil.
FCC Warning Statement:
Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user’s
authority to operate the equipment. This equipment has been tested and found
to comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC Radiation Exposure Statement The antennas used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be colocated for operating in conjunction with any other antenna or transmitter.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>