AUDEARA A02 Wireless Headset TV Bundle Installation Guide
- June 6, 2024
- AUDEARA
Table of Contents
AUDEARA A02 Wireless Headset TV Bundle Installation Guide
TV TRANSMITTER OVERVIEW
POWER THE TV TRANSMITTER
The TV Transmitter is powered by a USB-C cable.
Connect the USB-C end (smaller tip) into the back of the transmitter. Connect
the USB-A end (bigger tip) into your TV OR a USB wall charger.
Now, you should see the transmitter welcome screen. If you don’t see this screen, ensure your TV or wall charger is powered on.
CONNECT THE TV AUDIO
The Transmitter can be connected to the TV in three ways. We recommend using OPTION A for the best experience. OPTION A – TVs WITH DIGITAL AUDIO OUTPUT
Plug the DIGITAL OPTICAL cable into the TV Transmitter DIGITAL OPTICAL INPUT
Slide the Audio Input Switch to DIGITALPlug the other end into the OPTICAL
OUTPUT of your TV
OPTION B – TVs WITH 3.5mm HEADPHONE AUDIO OUTPUT Plug the ANALOG AUDIO cable
into the TV Transmitter ANALOG AUDIO INPUT Slide the Audio Input Switch to
ANALOGPlug the other end into the TV HEADPHONE AUDIO OUTPUT
OPTION C – TVs WITH RCA AUDIO OUTPUT (RED/WHITE PORTS)
DISPLAY AND STATUS
IN THE BOX
PRODUCT SUPPORT
Visit our website or call our friendly support team for more information. www.audeara.com/support +61 1300 251 539
FCC AND IC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
-
This device may not cause harmful interference,
-
This device must accept any interference received, including interference that may cause undesired operation.
FEDERAL COMMUNICATION COMMISSION INTERFERENCE STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -
Reorient or relocate the receiving antenna.
-
Increase the separation between the equipment and receiver.
-
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-
Consult the dealer or an experienced radio/TV technician for help
FCC CAUTION
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
ROHS COMPLIANCE
This product is in compliance with the European Union’s Restriction of Use of
Hazardous Substances in Electrical and Electronic Equipment (RoHS) Directive
2011/65/EU.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>