Shenzhen Junsida Electronic Technology M103 Wireless Mouse User Manual
- June 6, 2024
- Shenzhen Junsida Electronic Technology
Table of Contents
Shenzhen Junsida Electronic Technology M103 Wireless Mouse
Product Features
- Back to desktop
- Metal scroll wheel
- 3 levels of adjustable DPI(800/1200/1600)
- Silent click
- Cyclic fast charging system
Product Function Diagram
-
Left Button
-
Right Button
-
Scroll Wheel
-
Windows system: Back to desktop
-
DPI Button
(Light Version) Long press DPI button for 3 seconds to turn off the LED
-
Charging Port
-
ON/OFF Switch
-
Dual Mode switting
2.4GMode
Bluetooth Mode -
Receiver slot
6. Charging Port
7. ON/OFF Switch
8. Receiver slot
Instructions
Charging instructions:
It is recommended to use the computer use interface, to charge the mouse,
when charging the wheel Always bright red light, full of lights off, about 3
hours
Bluetooth mode: Push the bottom right switch down, that is the Bluetooth
mode
Receiver mode: Push the bottom right switch up, that is the receiver mode
2.4G+Bluetooth operation instructions(Dual mode Version)
Bluetooth mode: Push the bottom right with down, the Bluetooth mode
Receiver mode : Push the bottom rights with up, that ls, the receiver
mode
2.4G operation instructions(Single mode Version) Plug the NANO receiver into your computer”s use port and you’re ready go
iPad Instructions
-
UpdatetoiOS 13.system
-
After the system is updated, open Settings ➔ Accessibility ➔
Touch ➔ Assist Touch ➔ Open -
Move the mouse 1D Bluetooth pol ring mode, open the phone or tablet, search for pairing
Installation Notes
- Open the mmputer
- Plug the wireless “NANO Receiver'” into the computer’s USS port
- Push the “ON/OFF switch” on the bottom of the mouse1D the ‘ON” side.
- Move the mouse or tap the left and right buttons 1D use It normally.
Instructions for use
-
When the mouse moves slowly, please th eek if the battery is low.
It is recommended to charge it in timei -
When the mouse is not connected, please check if the power switch at the bottom of the mouse Is to med on, the NANO receiver is moved to other use interfaces for use;
-
If you are not using the mouse fur a long time. please turn off the power switch manually to save power .
Attention
- If the mouse is not used for a long time. it will automatically go to sleep. and you can move the mouse or Press any key to wake up.
- Bluetooth 5.1 version support: Wln8/Wln10/Mac/Android system.Support for ios 13 and above.
Read Manual Before Product use
§ 15.19 Labelling requirements.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
§ 15.21 Information to user.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
§ 15.105 Information to the user.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.