papalook E95A 5 Inches 1080P Full HD Baby Monitor User Manual

papalook E95A 5 Inches 1080P Full HD Baby Monitor

Packlng List

1. Camera Unir1
2. Monitor Unit*1
3. Type-C Power Cable*1
4. MicroPower Cable*1
5. Charging Plugs*2
6. User Manual*1

Camera Brief Introduction

1. 1080P Lens
2. Sensillum Opticum
3. Microphone
4. Decorative Hole
5. Gamera Recording TF Card Slot
6. Temperature Sensor
7. Power Socket
8. Speaker Hole
9. Reset Button
10. Heat Emission Hole

Screen Introduction

• RET/Menu
• Switch Camera
• Select Button/Camera Rotation Button
•  OK/Zoomin
• lnterphone
• Sound/Brightness
• Powe,
• Sound Detection Switch/Alarm Confirmation
• Antenna

Screen Icons

1. Signal
2. Powar
3. Sound
4. Temperature
5. Feeder Reminder Clock
6. .Music
7. Sound Detection
8. Real-time Carousel
9. Camera Channel
10. Time

• low power
• signal
• Sound Alarm
• Feeder Reminder
• Temperature Alarm

Manu Introduction

• Camera: You can select the camera channel (connect up to 4cameras at the same time, if you need to connect multiple cameras,you just need to select other channels and connect)
• Alan Clock: You can set meal time regularly {you can loop the alann or tum it off)
• Noise Detection: The screen will alarm if a sound is detected, like a chlld’s crying. (You can select 4 senslUve modes, lncludlng low, medium, high and tum off)
• Temperature Measurement: The ambient temperature can bedetected in real time, the screen will alarm if it is lower than 18° (65F) or higher than 30° (86F)
• Music: You can play a variety of soothing music
• AOD: You can set the screen display time (the screen enters screensaver state and enable power-saving mode)
• Video Recording: You can tum on or off the video recording. {Thisfunction requires the insertion of TF card. Support camera or screen recording. Please use Class 4 TF card, MAX 256GB)
• Replay: You can play the video. (This function requires insertion of TF card with video recording inside)
• System Setting: You can set time, restore system, use advanced settings and see system information
• Language Setting: It can support Eight language conversion

Connect to tha Camara

1. Position your Camera no lees than 10 feet away from your baby’s crib.
2. Press and hold Power Button 5 second.
3. You will hear “System starting upR 8-10 seconds after startup and then start working.

Q&A

• Q: Tile LCD screen shows no image.
  • Please make sure the camera is tumed on
  • Please reset the camera and reconnect if there is still no image when the camera Is turned on.
• Q: The screen power runs out very fast.
  • The display will always be in monitor mode and use time will be shortened if screensaver mode is not turned on. So, we recommend to set the screen entering screensaver mode when not to operate for certain time, which can save unnecessary electricity.
• Q: There wlll be noise when you call and the camera la too close to  the screen.
  • This is a nonnal physical phenomenon. Noise will be generated  when the two microphones are too close. This problem can be solved by turning down the screen sound or widen the distance  between them.
• Q: How to tum off tha alarm?
  • Press the alann confirmation button to tum it off.

Notes

• Tum off the power and store the LCD screen in a dry environment.
• Please charge the screen for 1 hour every 2 months if you don’t use it for a long time
• Use dry cloth to clean if necessary.
• Don’t drop the screen or camera from a height or onto a hard surface.
• Don’t expose the screen or camera to extreme temperatures. (Recommended storage temperature -10°c to so•c)
• Screens and cameras are not waterproof. Don’t expose the screen or camera to rain or allow liquids to enter any button ports or other openings.
• Don”t twist or bend the screen. This may lead to permanent  deformation.
• Don’t put the internal battery in the fire to avoid explosion.
• Please use the original charging plug and charging cable to avoid  accidents.

Warranty

Papa look Is covered by a 1-year warranty. For more information, please visit: www.papalook.com!

FCC Warning:

This equipment has been tested and found to comply with the limits for a Class B digital device, Pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.  This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Caution: Any changes or modifications to this device not explicitly approved by  manufacturer could void your authority to operate this equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions:

1. This device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance 20cm between the radiator and your body.

For more information, please visit our official website
www.papalook.com
Your valuable comments and suggestions on improvingpapa look products are welcomed!
support@papalook.com www.papalook.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>