Shenzhen B W Electronics Development BT022 Wireless Mini Numeric Keypad Instruction Manual
- June 6, 2024
- Shenzhen B W Electronics Development
Table of Contents
Instruction Manual
Wireless Mini Numeric Keypad
Model: BT022
CAUTION: To use this device properly, please read the instruction manual carefully before using it.
Hotkeys of Keypad
This keypad provides hotkeys of the top cover.
: Open the calculator
Esc: Same as Esc key function (when the calculator is open, it indicates
reset)
Other Advantages
- Power Saving Design: when there is no action for the keypad for about 10mins, it will enter a dormant state, just press any key that can activate it.
- Two AAA alkaline batteries: so the whole system voltage is 3V.
Install the Batteries
This wireless keypad uses two AAA alkaline batteries
Step 1: Remove the battery cover back by squeezing it from the keypad to
release it.
Step 2: Put the batteries inside as shown.
Step 3: Recover it.
Bluetooth Pairing
-
Switch to the ON position from the back of the keypad.
-
Long press key with 3 seconds until the LED1 shows red flicker.
-
Find Setting in your device, and turn on the Bluetooth function in your device.
-
Find and select “Bluetooth Keyboard” from the list and click to pair.
LED Indicator
This keypad has two red LED indicator lights.
- Turn the switch to the ON position, the LED1 light will go on and then go out after 3 seconds, then the keypad enters the Power Saving mode.
- Long press the key for 2-3 seconds, the LED1 will flick red, it indicates the keypad enters the pairing state.
- When the battery voltage is lower than 2.1V, the LED1 flicks red, please replace the batteries.
- When the NumLock function is ON, the LED2 will be bright, then you can input numbers by pressing the number keys.
- When the NumLock function is OFF, the LED2 will go out, and all numeric keys will be not effective, and the following is how the functions keys work:
Press Number 1: END
Press Number 2: DOWN
Press Number 3: PAGE DOWN
Press Number 4: LEFT
Press Number 6: RIGHT
Press Number 7: HOME
Press Number 8: UP
Press Number 9: PAGE UP
Press Number 0: INSERT
Press ” . “: DEL
FCC Statement
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly
approved by the manufacturer could
void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
RF Exposure Information
The device has been evaluated to meet general RF exposure requirements. The
device can be used in portable exposure conditions without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>