SPIELTEK 1003315 VR-BTR Virtual Reality Bluetooth Remote User Manual
- June 6, 2024
- SPIELTEK
Table of Contents
VR REMOTE CONTROLLER
MODEL 1003315
REV:01/ 2017-4-20
PRODUCT PHOTOGRAPH
OPERATING RATIO DISTRIBUTION
-
THE BOOT: LONG PRESS THE POWER ON/OFF BUTTON 3SEC, THE LED LIGHT INTO THE SLOW BLUE COLOR FLASH.
-
SEARCH SLOW LED LIGHTS FLASHING.
-
THE CONNECTION IS SUCCESSFUL THE LED LIGHT WENT OUT.
-
SYSTEM CHOICE: AUTOMATIC IDENTIFICATION android AND iOS SYSTEM,
-
SWITCH MODE: AFTER CONNECTION HOLD THE @BUTTON CLICK ON THE CORRESPONDING A-B-C-D KEY, YOU CAN SWITCH TO THE CORRESPONDING MODE.
SWITCH TO THE PRESS A-B-C-D KEY LED LIGHT PUT OUT. -
SHUT DOWN: SEACH WITHOUT AND MATCHING CONNECTION 3MINUTES AUTOMATIC SHUT DOWN, CONNECTION STATUS, WITHOUT AN OPERATION AUTOMATIC SHUT DOWN 10MINUTES.
-
LONG SHUT DOWN: PRESS THE POWER BUTTON FOR 3SEC, UNDER THE LED FLASH 10 TO TURN OFF.
FCC Caution.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
*RF warning for Mobile devices:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
a minimum distance 20cm between the radiator & your body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>