MOUNTAIN TOP ApS 552605 Push Button Module EVOe User Manual

MOUNTAIN TOP ApS 552605 Push Button Module EVOe

Introduction

Thanks for choosing the transmitter of the home security device. This product is a one-way RF technology-enabled device.

Specification

• Frequency Range: 433 MHz
• Operating Range: Up to 100 feet line of sight
• Operating Temp.: -10°C~ 50°C (14°F~122°F)

Remote

This is a remote control transmitter can control roll cover open and close.

Operation

1. Power on: supply +12V
2. Un-Lock mode: to the short circuit the “Unlock” pin and +12V for 0.1-3 sec. and then enter operation mode
3. To open the roll cover: Press the button and then the light flashes for 0.5 sec.
4. To close the roll cover: Press the button and then the light flashes 0.5sec.
5. Lock mode: to short circuit “Lock” pin and +12V for 0.1-3 sec.

Federal Communications Commission Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try and correct the interference by one of the following measures: Reorient or relocate the receiving antenna, Increase the separation between the equipment and receiver, Consult the dealer or an experienced radio/TV technician for help. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.

Limited Warranty

Vision Guarantees that every transmitter is free from physical defects in material and workmanship under normal usage for one year from the date of purchase. If the product proves defective during this one-year warranty period, Vision will replace it free of charge. Vision does not issue any refunds. This warranty is extended to the original end-user purchaser only and is not transferable. This warranty does not apply to : (1) damage to units caused by accident, dropping or abuse in handling, or any negligent usage; (2) units that have been repaired, taken apart, or modified by authorized personnel; (3) units not used in accordance with instruction; (4) damages exceeding the cost of the product; (5) transit damage, initial installation costs, removal cost, or reinstallation cost.

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>