Fire e-Control Remote Setup User Manual

October 27, 2023
Fire eControl

Fire e-Control Remote Setup

Remote setup and operating instructions

SET UP 2
Easy-to-use auxiliary remote to be used in conjunction with the Fire control app.

STEP ONE

Inserting/removing the battery

  • Insert a flathead screwdriver to unlock the cover.
  • Remove the cover.
  • Remove or insert the battery.

STEP TWO

Pair/unpair the remote

Pair

  1.  On the keypad, press the +/-buttons together on DIM 1, and the green LED will slowly flash.
  2.  On the remote, press the ON/OFF button to pair. If successful, the green LED will flash quickly on the keypad to confirm. The pairing mode lasts 12 seconds.

Unpair

  1.  On the keypad, press the +/-buttons together on DIM 2, the green LED will slowly flash.
  2.  On the remote, press the ON/OFF button to unpair. If successful, the green LED will flash quickly on the keypad to confirm. Unpairing mode lasts 12 seconds.

STEP THREE

LCD display icons

STEP FOUR

Operating the remote

  1. Thermostat
    Dim 1 brightness

  2.  Dim 1 color selection

  3.  Dim 2 brightness

  4.  Dim 2 color selection

Rotate the wheel to select a temperature, brightness, and color. There will be a delay as the remote, app & fire sync status.

OPERATING THE REMOTE

Thermostat
Heat on will retain the last temperature set by the remote or the app unless the fire is switched off by the master on/off switch, then it will default to 21° C. The heater will automatically cycle on & off within 2 degrees if the room temperature drops. The temperature may vary slightly between the actual room temperature and that of the reading inside the fire. Use the app or remote to adjust.

Open Window/Door Detection
If the fire senses a significant drop in room temperature, it will revert to LO Heat (showing the eco leaf) to save energy. HI Heat must be reset by the user once the door or window is closed and the room isolated.

Colour change
You may change the color of the flame and fuel independently of each other. There are 20 colors to choose from:

  • 1-4 Orange 13-16 Blue
  • 5-8 Red 17-20 White
  • 9-12 Green
  • You may also set a smooth color flow:
  • 21-24 Smoothly changes between the 5 main colors
  • 25 1-4 orange

The fire will retain the last color set by the remote or the app unless the fire is switched off by the master on/off switch, it will default to flame – orange 3 & fuel – flow 5.

Wall mounting
The back plate can either be stuck

or screwed to the wall

Troubleshooting

No power to the remote or the screen is blank Check the battery Remote is unresponsive, and icons show Remove battery and pair

Specification

  • Frequency: 2.4GHz
  • Battery operated: 3V CR2477 cell battery
  • Please ensure the battery is disposed of correctly

Help is at hand, for technical enquires please call 01543 251122 or email info@flameritefires.com www.flameritefires.com

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals