LEMONA SR-SB2819S RF Bluetooth RGB CCT Remote Controller Instructions

70010127

RF+Bluetooth RGB+CCT Remote Controller

Important: Read All Instructions Prior to Installation

Function introduction

Front side

1. 20 RGB color changing modes, click to play a mode, click again to pause current mode, click again to play next mode, press and hold down to speed up/down the modes
2. Click to turn ON/OFF all zones
3. Press and hold down to decrease light intensity
4. W button: to control color temperature: keep clicking to get 100%CW -> 50%CW+50%WW -> 100%WW -> OFF one by one, press and hold to decrease CW and increase WW, release and hold again to increase CW and decrease WW
5. Indicator: indicate the state of remote control
6. Color wheel, touch to select RGB color
7. Zone numbers:Click to choose the zone/zones, Press and hold down to turn on/off corresponding zone
8. Press and hold down to increase light intensity
9. Keep clicking to get CW, NW, WW mixed by RGB one by one, click again to turn off RGB channels
10. Press and hold down to save colors; Click to recall the saved colors

Bottom side

Product Data

• Control 4 zones of RF+Bluetooth receivers separately.
• RGB+CCT color controller
• High sensitive & high stable, fast & precise color control.
• Compatible with all universal series RF+Bluetooth receivers
• 1 receiver can be paired by max 8 different remote controls.
• Waterproof grade: IP20

Safety & Warnings

• This device contains AAA batteries that shall be stored and disposed properly.
• DO NOT expose the device to moisture.

Pair with RF+Bluetooth Receiver

Step 1: Do wiring the receiver according to wiring diagram(please refer to the instruction of RF+Bluetooth receiver that you would like to pair with.
Step 2: Click to activate the remote.
Step 3: Click ( RF+Bluetooth LED Receiver ) the “ Prog ” button or “ Reset ” button on the receiver or re-power on the receiver three times continuously to set it into pairing status
Step 4: Click a zone button to select a zone (e.g. zone 4).
Step 5: Then immediately touch the color wheel, LED lights connected with the receiver flicker once means the receiver is paired with zone 4 successfully.

If you use multiple receivers, you have two choices:
Option 1: have all the receivers in the same zone, like zone 1

Zone 1                                RF remote

Option 2: have each receiver in a different zone, like zone 1, 2, 3 or 4

Zone 1                      Zone 2                    Zone 3             RF remote

Save color/scene/mode

Step 1: Click ON/OFF button to activate the remote
Step 2: Choose and click one or multiple paired zone numbers(e.g. zone 4)
Step 3: Touch the color wheel or click the other buttons to select the scene you like
Step 4: Press and hold any scene buttons of S1-S3 (e.g. S3 ) , LED lights connected with the RF receiver flicker once means the color/scene was saved successfully.

Recall the saved colors/scenes

Step 1: Click ON/OFF button to activate the remote
Step 2: Choose and click one or multiple paired zone numbers(e.g. zone 4)
Step 3: Click any scene buttons of S1-S3 (e.g. S3 ) to recall the saved scene

20 Color Changing Modes:

• Colorful Mixed
• Red Shade
• Green Shade
• Blue Shade
• Yellow Shade
• Cyan Shade
• Purple Shade
• White Shade
• Red Green Shade
• Red Blue Shade
• Green Blue Shade
• Colorful Strobe
• Red Strobe
• Green Strobe
• Blue Strobe
• Yellow Strobe
• Cyan Strobe
• Purple Strobe
• White Strobe
• Colorful Jump

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>