Superior Communications LC07 15W Magnetic Wireless Charger User Manual

Superior Communications LC07 15W Magnetic Wireless Charger

Thanks for choosing us!
This is a smart phone wireless charger that allows you enjoy the fun of digital products easily. Please kindly read the user manual before using and keep it for future reference

Specification

• lnput :DCSV3A, DC9V2.22A, DC12V 1.67A
• Charging distance: ,s;;10mm
• Output: SW/7.SW/l0W/lSW
• Conversion: ;,.12%
• Frequency : 115·205KHZ
• Dimensions: ctl63X10.5mm
• NW. :57g

Connect to Power Adapter

• Connect the power adapter to socket.
• onnectadaptertotheType-C interface.
• The white LED light of charger will flash 3times when power on, then enter to standby mode.
  • 20W PD wall charger need to buy separately, please use the connector adapter accordding to your wall charger USB output port.

Charging Mode

1.  Make sure the wireless charger dock connect to the power supply.
2. Put the magnetic wireless charging phone one the charger, they will align automaticly, white LED light will turn off after 30 seconds.
3. The white LED light will flashing when FOD detected.
4. The device also support wireless charging to other nonmagnatic wireless charging function device.

Notes

1.  Do not squeeze or collisions.
2.  Do not disassemble or throw into fire or water, to avoid causing a short circuit leakage.
3.  Do not use wireless charger in severely hot, humid or corrosive environments, to avoid circuit damage and occurs leakage phenomnon.
4.  Do not place too close with magnetic stripe or chip card ( ID card, bankcards, etc.) to avoid magnetic failure.
5.  Please keep the distance at least 20cm between implantable medical devices ( pacemakers, implantable cochlear, etc.) and the wireless charger, to avoid potential interference with the medical device.
6.  To take care of the children, to ensure that they won’t play the wireless charger as a toy, to avoid unnecessary accidents.

IC Caution :
THIS device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:This device may not cause interference.This device must accept any interference, including interference that may cause undesired operation of the device. RF exposure statement:The equipment complies with IC Radiation exposure limit set forth for uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator and your body.

FCC WARNING

This device complies with part 15 of the FCC Rules.Operation is subject to the following two conditions:

1.  This devicemay not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in aresidential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

1.  Reorient or relocate the receiving antenna.
2.  Increase the separation between the equipment and receiver.
3.  Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
4.  Consult the dealer or an experienced radio/TV technicianfor help.
5. To maintain compliance with FCC’s RF Exposure guidelines, This equipment should be installed and operated with minimum distance between 20cm the radiator your body: Use only thesupplied antenna.

IC Caution:
Radio Standards Specification RSS-Gen, issue 5- English:This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:This device may not cause interference.This device must accept any interference, including interference that may cause undesired operation of the device. RF exposure statement:The equipment complies withIC Radiation exposure limit set forth for uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator and your body.

1.  French:Cet appareil contient des émetteurs / récepteurs exemptés de licence conformes aux RSS (RSS) d’Innovation, Sciences et Développement économique Canada. Le fonctionnement est soumis aux deux conditions suivantes:Cet appareil ne doit pas causer d’interférences.Cet appareil doit accepter toutes les interférences, y compris celles susceptibles de provoquer un fonctionnement indésirable de l’appareil.
2. The involved images are sketch maps, the final product as per the material subjects.Includes: wireless charger,USB output port, user’ s manual.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>