BUGANI M118 Wireless Portable Bluetooth Speaker User Manual

: June 6, 2024
: Bugani

Table of Contents

DIAGRAM OF CONTROLS
PRODUCT FEATURES
TECHNOLOGY SPECIFICATION
WHAT’ S INCLUDED
WIRELESS PAIRING
GUIDANCE
CARE AND MAINTENANCE
LIMITED WARRANTY
PREFERENCE TEMPERATURE
Read User Manual Online (PDF format)
Download This Manual (PDF format)

M118
Wireless Speaker
USER MANUAL
PREFERENCE TEMPERATURE

DIAGRAM OF CONTROLS

JACK

INDICATOR LIGHT

Red indicator:
Aux•in meek: red indicator is always
Blue indicator:
Wireless mode: last flatting ready to paring &Nays on flaked successful and ready to play. slowly flashing — playing musk

PRODUCT FEATURES

Wireless version: 5.0
Aux-in function
Surprisingly loud volume with deep bass.

TECHNOLOGY SPECIFICATION

Model No. M118
Speaker impedance: 40
Sensitivity: 97dB (01 kHz 1 M)
Speaker driver size: 4’•2
Product size: 348’208’130mm

CAUTION
The danger of explosion if the battery is incorrectly replaced Replace only with the same or equivalent type noted:

A warning that batteries (battery pack or batteries installed) shall not be exposed to excessive heat.
Do not use usb charging at the same time when playing songs.

WHAT’ S INCLUDED

Wireless speaker — 1pc
User manual — 1pc
USB-C Charging cable — 1pc
Aux-in cable — 1pc

WIRELESS PAIRING

Turn on your Ml 18, you will hear starting music, the Blue LED is flashing, which means the speaker is ready to pair. Next, open your device to look for the speaker name “BUGANI M118-and connect to your device.
Once paired successfully, the LED indicator turns blue and makes beeping.

Note:

If the Wireless weaker is in low power or weak state, sometimes it may not be connected to the phone.
When the mobile phone device is connected, if it exceeds the connection distance over 10N, the signal will be disconnected. But it will automatically connect when the phone is close to the speaker.

GUIDANCE

Please read the usual manual before using it.
Please give the speaker fully charged before using.
11 the unit been left unused for over 2 weeks, please charge it again.
Please choose the certificated power adapter for input charging.

CARE AND MAINTENANCE

Long press 2 seconds to turn off the device, to make sure that it is properly protected;
Avoid high temperatures (above 40 degrees Celsius), for example, in hot cars or in direct sunlight. (High temperature will be damage the surface and reduce battery life.)

LIMITED WARRANTY

BUGATTI products that it will furnish a replacement or repair any part which proves (upon inspection by BUGANI) to be defective under normal use within 18 months of the original purchase date.
This warranty does not apply to appearance items and accessories in the c human damage caused by leaking batteries. It also does not apply to the product, or to any part thereof, that has been damaged through misuse or negligence, or improper installation operation.
Furthermore, this warranty will become invalid, in the judgment of BUGANI products or any parts that have been installed incorrectly, repaired, or altered by other than the BUGANI Service department.
This warranty gives you specific legal rights and you may also have other rights which vary from state to state. Some states do not allow the exclusion or limitation of incidental or consequential damages or limitation of incidental or consequential damages or limitations on how long an implied warranty lasts, so the above exclusions and limitations may not apply to you. For Service, Warranty, or Product Information, Please contact support@bugani.vip

PREFERENCE TEMPERATURE

0°c – 45° c
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
FCC STATEMENT

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the KC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there Is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help.
RF warning statement:
The device has been evaluated to meet the general RF exposure requirements. The device can be used in portable exposure conditions without restriction.