AXIOMTEK ITC080 Face Recognition Temperature Measurement Terminal User Manual
- June 6, 2024
- AXIOMTEK
Table of Contents
AXIOMTEK ITC080 Face Recognition Temperature Measurement Terminal
**Frame description
**
Product size ( mm)-Column style
Product size ( mm)-Wall hanging style
Power on settings network and device activation
Set server, company, community name, installation location and access mode
Face input of local device (click the face mark in the lower right corner with the cursor)
Select the gate settings – click “open face management
Face registration
Select single person registration & batch import face for registration
Mask mode
(When the mask mode is on, the device recognizes the user without the mask.
and prompts to wear the mask. The device flashes red status light to indicate
early warningl)
Stranger mode
(Turn on stranger mode. the device will flash red status light for unregistered face users to show early warningl Don’t open the door!)
CE NB
Herby, AXIOMTEK Co., Ltd declares that this Face recognition temperature
measurement terminal，ITC080 is in compliance with the essential requirements
and other relevant provisions of Directive 2014/53/EU. In accordance with
Article 10(2) and Article 10(10), this product allowed to be used in all EU
member states. Use the Face recognition temperature measurement terminal in
the environment with the temperature between -20℃ and 35℃, Adapter shall be
installed near the equipment and shall be easily accessible. The plug
considered as disconnect device of adapter
Adapter Model: TDX-1202000
Input: AC 100-240V, 50/60Hz, 0.6A Output: DC 12V, 2.0A
Operation Frequency: For WIFI: 2412MHz~2472MHz (802.11b/802.11g/802.11n(HT20))
For BT: 2402MHz~2480MHz
Max output power: For WIFI: 0.0555W
FCC Statement
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions (1)this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment should be installed and operated with a minimum distance of 20 centimeters between the radiator and your body.
**DIECLARATIOIN OF CONIFORMIITY
**
Documents / Resources
|
AXIOMTEK ITC080 Face Recognition Temperature Measurement
Terminal
[pdf] User Manual
ITC080, 2ATPY-ITC080, 2ATPYITC080, ITC080 Face Recognition Temperature
Measurement Terminal, ITC080, Face Recognition Temperature Measurement
Terminal
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>