SelectBlinds Classic Routeless Faux Wood Blinds Installation Guide
- June 6, 2024
- SelectBlinds
Table of Contents
SelectBlinds Classic Routeless Faux Wood Blinds
TOOLS
GETTING STARTED – TOOLS NEEDED FOR INSTALLATION
Rechargeable Drill with 1/4” Hex Bit / Phillips Screwdriver / Pencil / Tape Measure
UNPACKING THE PARTS
Locate the parts and brackets in hardware box.
The quantity will vary with blind size.
Hold-down parts will only be sent for blinds that have requested this option.
Center Support Bracket will only be sent for blinds over 37” wide.
-
Installation Brackets
-
Valance Clips
-
Center Support
-
End Cap for Hold-downs
-
Hold-down
-
Bracket
-
Installation Screws
BRACKET PLACEMENT
IF APPLICABLE:
Center Support Bracket
VALANCE CLIPS & WAND
-
Attach Valance Clips
-
Assemble the Wand
Snap together where applicable.
FINISHING UP
-
Slide into Brackets
-
Attach Wand
-
Install Valance
IF APPLICABLE:
Hold-down brackets
OPERATING INSTRUCTIONS
Raise or lower the blind by lifting or lowering the bottom rail to the desired height.
PLEASE NOTE : This product is made up to +6” of ordered height. Blinds over 84” may include up to 10” of additional height. This is normal for this product and not considered a manufacturing error or defect.
Open or close the blind slats by turning the wand until the slats are opened or closed to the desired amount.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>