MUSGO HB1 Portable Wireless Speakers User Manual
- June 6, 2024
- MUSGO
Table of Contents
HB1 Portable Wireless Speakers
The default bass function is turned on. Press the TWS button for 3 seconds.
After hearing the beep, turn off or turn on the bass function.
Speaker Button Operation and Port Function
Power button: Long press to turn it on, a beep will appear, and the indicator
light will be blue. Long press the power button again, a beep will appear, the
indicator light will go out, and the power will be turned off.
Wireless speaker USB port can be used for emergency charging of mobile phones or Tablet computer.
Functions after TWS connection: Operation synchronization of two speakers(does not contain power button).Press the buttons on one of the speakers to achieve the same effect on the other speakers the buttons include (+/-/ volume/Previous/Next/Play/pause).
flash disk
USB
After booting, the indicator light flashes blue quickly. Thewireless speaker is successfully connected, and the indicatorlight flashes blue slowly. Insert the TF card/USB /AUX cable theindicator light flashes green quickly. While chargingplug in thechargingcable, the indicator light will be red without flashing,and theindicator light will be off when the battery is fullycharged. Whenthe wireless speaker is running low power , theindicator lightflashes red quickly (accompanied by a short beep).
Hands-free function
Built-in microphone, dial a mobile number, select ” HB1″ in the hands-free
bar, and make hands-free calls through smartphones and iPhones.
In boot mode, insert the USB flash disk, the speaker automatically plays the U
disk music, USB flash disk music supports MP3, WMA, SBC, WAV format. The USB
flash disk supports up to 64G capacity. In boot and shutdown mode, insert the
USB charging line, can charge the mobile phone and other devices in an
emergency , the output voltage is 5V 2A.
In boot mode, insert the AUX audio cable, automatically switched to AUX mode,
the speaker plays AUX source music.
iron
FCC Statement
This device complies with Part 15 of the FCC rules. Operation is subject to
the following two conditions: 1) this device may not cause harmful
interference, and 2) this device must accept any interference received,
including interference that may cause undesired operation. Note: This
equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures: –Reorient or relocate the receiving antenna.
–Increase the separation between the equipment and receiver. –Connect the
equipment into an outlet on a circuit different from that to which the
receiver is connected. –Consult the dealer or an experienced radio/TV
technician for help. Changes or modifications not expressly approved by the
party responsible for compliance could void the user’s authority to operate
the equipment.
Radiation Exposure Statement The device has been evaluated to meet general RF
exposure requirement. The device can be used in portable exposure condition
without restriction.
USB flash disk port
P
6 Months
MAH/3.7V USB Type-C
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>