Dongguan Feiying Electronics SX-5513 Car Player User Manual

Dongguan Feiying Electronics SX-5513 Car Player

Panel function

1. Switch button Up and down tuning
   knob Function conversion key

2. Volume knob Sound adjustment

3. SD card

4. Answer button Band switching

5. Hang up /time

6. Pause playback

7. Browse Play

8. Single cycle

9. Shuffle Playback

10. Decrease by ten

11. Add ten to the front

12. USB

13. AUX 14.RESET

Audio Files

1. Perfectly Supports All Lossless Music, FLAC, APE, WAV for instance;
2. MP3, WMA

MP3 formats detailed description as below

1. Sampling Frequency: 8K-48K
2. Bitrate: 8Kbps-448Kbps
3. Bitwide: 16bits
   Sound Track: Mono, Stereo. Supports MPEG1/ MPEG 1/MPEG2,(layer1,2,3) MP3 CBR/VBR/AB max encoding rate 448kbps; supports MP3 ID3V2; supports WAV ima/microsoft ADPCM;
   supports WAV PCM; Supports WMA(V7/V8/V9); supports WMA bitrate>=5 kbps; supports MP3/WAV/WMA sampling rate (K):8/11.025/12/16/22.05/24/32/44.1/48 FLAC 168IT, sampling rate (K):8/11.025/12/16/22.05/24/32/44.1/48

Bluetooth instructions

Device Name: CAR BT
PIN Number: 0000
Bluetooth connection method: When the machine is powered on, the phone turns onthe Bluetooth function, clicks on the search device. When [CAR BT] is displayed in the list, click [CAR BT] to connect. Bluetooth plays mobile music: After the Bluetooth connection is successful, open themusic player software on the mobile phone to play music, increase the volume of the mobile phone, and press the MODE button repeatedly until the BT AUDIO (Bluetooth mode) is displayed, it is already playing. Bluetooth name can not be searched or searched for connection unsuccessful? Solution: Cancel all other Bluetooth devices connected to the phone, and then click again to search for the device. If the problem is still not solved, you can search/connect several times. If it still doesn’t work, unplug the host and wait for 1 minute, then power on again, and then search for connections.
New Functions:
Folder up/down Function. For example, if there are 3 folders in 1 USB drive, 10 tracks in each folder. Long press #6 is folder up, i.e., the 1st track of the 2nd folder can be read; long press #5 allows VOu to go to the 1st track of the previous folder.

Rapid Track Select Function

if there’re hundreds of songs in 1 USB drive, suppose you want to listen to the 100th track, you won’t have to press 100 times to get there. Under Music Mode, short press BAND/APS to enter rapid track select status.4 zeros will display on the LED panel, the 1st zero on the right blinks; adjust the VOL button to get the single digit. After that, press BAND/APS to get the cursor to tens digit, also adjust the VOL button to the tens digit. Similarly, press BAND/APS to get the cursor to hundreds digit, adjust the VOL button to it, press the middle of vOL to confirm, voila, you get to listen to the 100th track.

Remote function

1. The power switch
2. Mode conversion/Phone Hand up
3. Volume increase
4. Volume reduction
5. Multi fnuctional selection Key
6. digital key
7. Mute function
8.  Search for stations a AMS
9. Sound settings DISP
10. Scan feature selections
11. Scan feature selections
12. Band conversion BAND/
13. Equal loudness
    Phone Pick up

WELCOME
Thank you for purchasing our products,Read all ‘manual” to understand the correct operation of this type of product method, Keep reading after the completion of, To service future reference

Important Reminder

If your car in direct sunlight where, Cause excessive heat inside the car, Should enable the unit to cool before use. If your car on the outside a very cold place Should first start the car, To betemperature before using the machine.
If the machine does not power supply, Please check the connection status. If everything is normal, Check the fuse. Play USB, Please be careful not to crash, Cause the machine to prevent damage, For a long time when not, Remove the USB or TF card. To prevent a short circuit, Do not place metal objects (Screws, coins, tools) and other components falling into the device. To protect traffic safety, Please do not concentrate on driving the process of regulating the product. Before installation, Refer to the wiring diagram. Note that connection, Avoid short circuit. The unit accepts music format MP3/ WMA, Do not download pictures and video files to play on this unit, Or can not play or slowdown playback, If the current player is the MP3 format, Display shows MP3, If the WMA format will be displayed as WMA In the USB or TF card, please be careful not to another line of wool or hair into the UBS or
TF tilting deck, TO avoid poor contact. Connect the computer to add, and delete files, please make full use of the rear computer USB port.

Installation Instructions

Please refer to installation, wining diagram Instalalion of metal sleeve See installation drawings,the metal set into the instrument panel, with the driver put the top card of metal to fixed locations, Power and Polarity, positive and the car battery positive and negative ground battery negative or frame at the end ( note that, in order to prevent a shore circuit, all installed, then teh negative battery connected) Yellow (memory wire): the positive connections with 12
mamon lines: Error for l 1 r author and Anita switches and this line with the vehicle ignition switch control): toy connection Speaker win
This device is designed to use 4-8’n load impedance speakers, connected to speakers before you disconnect short circu
Note: Do not use the speakers connected to the ground with the body or even touch each other, not to collide otherwise it will damage the machine Replace the fuse bad first pull out the fuse. the new standards have the same fuse inserted in the output hoicks see wiring diagram)install the host: the antenna into the antenna base, the right to adjust the antenna if they can, you may get a good rore if they can, you may geta g000 reception.

Troubleshooting and Maintenance

Sometimes considered a failure phenomenon is a small operation or a result of wiring errors. Before calling that, please fert o the following description of a brief examination :

1. Unreasonable power?
   Fuse box: Make sure there is no short circuit between wires, replace the fuse the same melting capacity Auto Ignition SystemACC position: the same guidewire airy wire, connected to the ignition wire as the battery wire the memory is connected to power lines and power supply positive.

2. Press the off button does not work: the panel has a reset Dutton please reset, in genera, you the work, if itis still mot WoTKIng property,u power cord then plug the time (orohahv now dnd then re-plug Should be able to work properly ged in)

3. Does not respond after opening LOUD: such cases the tuning source used tor the selection of tuning the source no bass compensation

4. Silent or whispered: volume control or balance stings are set on one side, the fader and balance settings at the central position; input/ output wires or wiring harness are connected properly: Please refer to wiring diagram sound too excessive or load Weight, the machine automatically protection: after the machine automatically cooling back to normal

5. Sound, quality(distortion) Speaker wires is being pinched by a screw, check the speaker wires are not wired the speaker output terminals, respectively.to the speaker terminals. Check the telescopic antenna is nomnal, check the antenna input socket s good, with or without contact with the defect.

Specifications

• FM radio

• Tuning Range 87.5-108.OMAHA

  ---

• Sensitivity 20DB

• Stereo Separation 2250B

• SNR a6ODB

Some playback

• Music format support MP3. WMA
• Misplay Format ID 3 displays
• Distortion s0.3%
• SNR a60DB

Panel Size 188wide x 78deep x s8high-MM
Installation dimensions 178wide X 78deep x50high-MM
Power supply 12VMachine 11-14.4V
Note: This machine is 12V machine, not according to the 24V power supply

Audio
Operating temperature 20-+60C
quiescent current speaker impedance 40
Frequency Responses 20020000HZ
Fuse
Yellow -10A

FCC Warning

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions (0) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Note: This equipment has been tested and found to comply with the limits fora Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for he

Note: The Grantee is not responsible for any changes or modifications not expressly approved by the party responsible for compliance. such modifications could void the user’s authority to operate the equipment. The device has been evaluated to meet general  RF exposure requirements.

To maintain compliance with FCC’s RF exposure guidelines, the distance must be at least 20 cm between the radiator and your body, and fully supported by the operating and installation configurations of the transmitter and its antenna(s).

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>