Shenzhen Imoon Technology K01 Remote Control User Manual
- June 5, 2024
- Shenzhen Imoon Technology
Table of Contents
PRODUCT OVERVIEW
SPECIFICATION
Name: Kol
Model: MY-K01
Size: 643218.5mm Color: Black/Purple/Rose red/Deep red
Material: ABS
Battery: 240mAH Li-battery
How to use
Turn On/Off
Long press the power button for two seconds to turn on
Long press the power button for two seconds to shut down
INTENSITY ADJUSTMENT
Turn on to be first intensity press the power button to increase one level
Note:lt will automatically turn on the standby mode after 20 minutes of
no use. The machine will automatically shut down if there is no operation on
the buttons within ten minutes o standby.
SIGNAL LIGHT
The signal light keeps on blue when the machine is turned on
ABOUT CHARGING
CHECKLIST
Remote control x1
Manual x1
PROHIBITION
- Prohibition of use by minors
- Forbidden to disassemble and discard this product at will
- Please keep out of the reach of children
- Please stop using if you feel unwell during use
- Please stop using it If any damage is found
- Please do not use it if you are injured
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirements. The
device can be used in portable exposure conditions without restriction
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>