personal comfort GR01WR Wireless Remote Control Instructions
- June 5, 2024
- personal comfort
Table of Contents
personal comfort GR01WR Wireless Remote Control
Two wireless remotes
- Air control unit can have two remotes connected
- Remote will function for selected side until user makes a change
Single remote option
- You can also set up the air control unit to be operated by one wireless remote
- Single remote option is required for single sleeper, queen, full, double twin xi and twin-sized number beds
Side of the bed
- Select side of bed for function
- Pump can utilize two remotes
- Remote will function for selected side until user makes a change
“Side ot the bed Is based on laying In bed on your back.
Operation
- First press turns on remote/ LCD
- Select Firm or Soft
- Firm= pump inflates chamber
- Soft= pump deflates chamber
- Press or “press and hold”, display will show changing value
- Once stopped, adjustment will be made after two seconds
- While adjusting, arrow will flash
- Cancel any operation by pressing any key
Simultaneous use
Low battery indicator
Memory
Battery install
FCC ID: 2AEM2GR01WR
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
INSTRUCTION TO THE USER
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
In order to maintain compliance with FCC regulations, shielded cables must be used with this equipment. Operation with non-approved equipment or unshielded cables is likely to result in interference to radio and TV reception. The user is cautioned that changes and modifications made to the equipment without the approval of the manufacturer could void the user’s authority to operate this equipment.
American
National
Manufacturing,
Corona,
CA
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>