Delighted CTRC1US193RDTV Remote Control Instruction Manual
- June 5, 2024
- Delighted
Table of Contents
PAIRING REMOTE STEP
Press the Home button and Hold about 10-15seconds, Until the LED Starts to rapidly flash then release. waiting about 60 seconds (Entering Pairing mode, LED Flash), then the remote should automatically pair with your TV. the TV will display remote connecting success When the light goes out if the remote is still does not Pair success. Please Firstly Remember
- Unplug the power cord and then plug back the power cord of the Amazon Fire device.
- Remove the battery and insert back the battery of the remote.
- Then please Repeat the above pairing step: Press the Home button and Hold for about 10-15 seconds, Until the LED Starts to rapidly flash then release. waiting about 60 seconds (Entering Pair mode), then the remote should automatically pair with your TV.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly
approved by the manufacturer could void your authority to operate this
equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
RF Exposure Information The device has been evaluated to meet general RF
exposure requirements. The device can be used in portable exposure conditions
without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>