NEOVICTORY EROICA BoneSound Wearable Series TWS Glasses Instructions
- June 5, 2024
- NEOVICTORY
Table of Contents
NEOVICTORY EROICA BoneSound Wearable Series TWS Glasses
Illustration
Communication Paring to Your device
- Turn on the Bluetooth on your device.
- Push the MFB button to power on the TWS Glasses devices respectively. The LED Indicators become breathing mode, gradually lighter and darker.
- Search the TWS Glasses device, which is named BONE, on your device.
- While the connection is built up between your device and TWS Glasses, the LED of the master TWS device will become flash mode.
Note. The master TWS device built the connection to your device with Bluetooth first
Power – ON/OFF
Hold on any side of the MFB button for 3 secs. Both sides should control respectively.
Music – Play/Pause
One-short push on any side of the MFB, this operation will be accepted in each TWS device.
Volume – Up+/Down-
Hold on the MFB button on the right-hand side device, a notification sound will be played. This operation will increase the 5-level volume sequentially.
EQ mode – Mode switch
Hold on the MFB button on the left-hand side device, a notification sound
will be played. This operation will switch the 3 EQ modes sequentially.
Coming Call – Answer call / Hang up call
One-short push on any side of the MFB on each TWS device.
TWS reset – Forget all connected information
After powering on the TWS devices, hold on to the MFB button for over 10
secs. While the LED indicator becomes dark, release the MFB button.
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation
This device has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This device generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this device does cause harmful interference to
radio or television reception, which can be determined by turning the device
off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the device and receiver.
- Connect the device to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>